2. Using the following data, calculate the average atomic mass of magnesium (give your answer to the nearest
.01 ) : Show all work!
Isotope: Mg Percent abundance: 78.70%
24
Isotope: 'Mg Percent abundance: 10.13% 25
Isotope: Mg Percent abundance: 11.17% 26

Answer:

The release into the air of chemicals and particles can cause direct damage to the troposphere (air pollution); alter the composition and function of atmospheric layers (greenhouse effect) or other indirect damages (ozone layer depletion).

Explanation:

Answer:

their are many alternative for cornstarch.But I know only 10 of them and they are:

1.Rice Flour

2.wheat Flour

3.Potato Starch

4.Arrowroot

5.Tapioca

6.Ground Flaxseeds

7.Gaur Gum

8.Xanthan Gum

9.Glucomannan

10.Xanthan Gum

Answer:

[CO2] > [N2] > [He]

Explanation:

The relative concentration of CO2, N2 and He depends on the solubility of each gas in water. The more soluble in water a gas is, the greater its concentration in aqueous solution.

Among the gases listed, CO2 is most soluble in water hence it is expected to have the greatest concentration in solution followed by N2. Helium gas is insoluble in water hence it has the least concentration in the aqueous solution.

Answer:

Styrofoam could be heavier than a rock depending on how much weight you put on it,

Water is heavier than a ping pong ball,

A gold ring is not heavier than a pencil,

Oil is heavier than water because of the combined mass.

A large log is heavier than a small rock.

Explanation:

Answer:

.0924 moles of NaCl

Explanation:

So you know you have 5.4 g of NaCl and you need to know how many moles there are in this amount of NaCl

Add these two together----> 22.99 + 35.45 = 58.44

Now you can calculate for moles

Written-out method:

5.4 grams of NaCl  |   1 mole of  NaCl              

                                | 58.44 grams NaCl                = .0924 moles of NaCl

Plug into calculator method:

(5.4 g of NaCl/ 58.44g NaCl= .0925 moles)

Answer: If the outer shell is filled, the atom is stable. Atoms with unfilled outer shells are unstable, and will usually form chemical bonds with other atoms to achieve stability.

(hope this helps ^^)

Answer:

[tex]A=275.1g[/tex]

Explanation:

Hello.

In this case, since the radioactive decay is computed via:

[tex]A=A_0*2^{-\frac{t}{t_{1/2}}[/tex]

For the initial amount of Ra-226 (300 g), once 200 years have passed, the remaining mass is:

[tex]A=300g*2^{-\frac{200years}{1600years}}\\\\A=275.1g[/tex]

This is, considering that the half-life is 1600 years, it means that the mass of Ra-226 is decreased.

Best regards.

The Lewis Dot Structure for ionic compounds must demonstrate how the electrons are transported to create the ions in the compound. The Lewis Dot Structures of covalent compounds must demonstrate how the electrons are being shared to finish the octets of each atom in the molecule.

A chemical compound known as an ionic compound is one that contains ions bound together by the electrostatic forces known as ionic bonding. Despite having both positively and negatively charged ions, or cations and anions, the molecule is generally neutral.

The term "ionic bonding" refers to a bond in which the ionic character is greater than the covalent character, i.e., when there is a significant difference in the electronegativity of the two atoms, which makes the bond more polar (ionic) than in a covalent bond, where the electrons are distributed more evenly.

The Lewis structures are not frequently drawn for ionic compounds due to the electrical motion of electrons.

Thus, The Lewis Dot Structure for ionic compounds must demonstrate how the electrons are transported to create the ions in the compound.

To learn more about an ionic compound, follow the link;

https://brainly.com/question/9167977

#SPJ2

Answer:

extensive properties

Explanation:

,such as mass and volume, depend on the amount of matter being measured. Intensive properties, such as density and color, do not depend on the amount of the substance present. Physical properties can be measured without changing a substance's chemical identity.

Answer:

Propionic acid

Explanation:

Step 1: Write the generic neutralization reaction

HA + NaOH ⇒ NaA + H₂O

Step 2: Calculate the reacting moles of NaOH

21.85 mL of 0.1062 M NaOH react.

0.02185 L × (0.1062 mol/L) = 2.320 × 10⁻³ mol

Step 3: Calculate the reacting moles of HA

The molar ratio of HA to NaOH is 1:1. The moles of HA are 1/1 × 2.320 × 10⁻³ mol = 2.320 × 10⁻³ mol.

Step 4: Calculate the molar mass of HA

0.1719 g of HA correspond to 2.320 × 10⁻³ moles.

MM = 0.1719 g/2.320 × 10⁻³ mol = 74.09 g/mol

With this molar mass, the most likely acid is propionic acid.

Answer:

b. only weather includes information about the temperature

Answer:

c. stays the same, changes

Explanation:

temperature and heat go hand in hand, however while the change of state occurs, the temperature remains the same while the heat increases since the heat input is constant.

As a change of state takes place, heat and temperature: C. stays the same, changes.

Matter can be defined as anything that has mass and occupies space. Thus, any physical object or substance that is found on earth is typically composed of matter.

Since all matter are made up of atoms, they have a property of existing in three (3) distinct states and these include;

Generally, matter changes state when heat (thermal energy) is released or absorbed with a corresponding change in its temperature.

In conclusion, at the point when the change of state is taking place, heat stays the same and temperature changes.

Find more information: https://brainly.com/question/17203857

The two properties which can be measured from the given information are streak and cleavage of the mineral.

Minerals are naturally forming inorganic substances having crystal structure and metallic characteristics. They have a definite chemical composition and  homogeneity.

Streak is the color of powder form of mineral and cleavage is how the mineral cleave when we cut through a plane.  Hardness says how much hard the solid is.

When the mineral breaks into cubes when struck with a hammer, we measure its cleavage properties. The red trail on scrapping indicates the streak of the mineral.

Hence, the two properties we can measure from breaking by hammer and scrapping by an unglazed porcelain are its cleavage and streak.

To learn more about minerals, refer the link below:

https://brainly.com/question/18078524

#SPJ2

Answer:

3 - coefficient

2 subscripr

6 total #

cl- element symbol

Answer:

True

Explanation:

Sorry if this is late lol

Answer:

The answer is True.

Explanation:

Did not copy

Answer:transition metal ionic compound with nonmetal anion

Explanation:

Answer:

Your answer is going to be D. transition metal ionic compound with nonmetal anion

Hope this helps :)

Answer:D. Sulfur Hexafluride

Explanation:

D. Sulfur Hexafluride

Explanation:

above it says the substance floats above water at room temperature and lists some substances and their density at room temp!

we know that the density of water is 1.0 so the substance in order for it to float has to be less than 1.0 and the densities for Sulfer Hexa, are all less than 1!!

Answer:

B. 3.0 g/ml

Explanation:

density formula: mass/volume

15/5=3

Answer:

Explanation:

I hope this helps

Answer:

The balloon will occupy a volume of 1.32L.

Explanation:

Given the following data;

Original Volume, V1 = 1.03L

Original Temperature, T1 = 99°C

New Temperature, T2 = 198°C

To find new volume V2, we would use Charles' law.

Charles states that when the pressure of an ideal gas is kept constant, the volume of the gas is directly proportional to the absolute temperature of the gas.

Mathematically, Charles is given by;

[tex] VT = K[/tex]

[tex] \frac{V1}{T1} = \frac{V2}{T2}[/tex]

Converting T1, from Celsius to Kelvin = 273 + 99 = 372K

Converting, T2, from Celsius to Kelvin = 273 + 198 = 471K

[tex] \frac{V1}{T1} = \frac{V2}{T2}[/tex]

Making V2 as the subject formula, we have;

[tex] V_{2}= \frac{V1}{T1} * T_{2}[/tex]

[tex] V_{2}= \frac{1.03}{372} * 471[/tex]

[tex] V_{2}= 0.0028 * 471[/tex]

V2 = 1.32L

Therefore, the balloon will occupy a volume of 1.32L at 198°C

Answer:

endothermic means energy is taken in and temperature increases.

Answer:

The answer is boiling point

Answer:

the element is lead

Explanation:

the atomic number of lead is 82.

number of protons 82

number of electrons 82

C or D i think maybe

Answer:

D and A

Explanation:

Answer:

4

Explanation:

In CH3OOH, there is H3, which means 3 hydrogen atoms, but there is also an H at the end, which means another hydrogen atom.

3 + 1 = 4

Answer:

AR(18)  

Explanation:

Try that it should work

                                                                                                                                         *(

Given parameters:

Number of moles of Nitrogen = 2.0mole

Temperature of the gas = 1000c

Pressure on the gas = 100000Pa

Gas constant R = 8.31J/molK = 0.082atmdm³mol⁻¹k⁻¹

Unknown:

Volume in cubic meter and cubic decimeter = ?

Solution:

The ideal gas law is given as;

       PV  = nRT

where P is the pressure on the gas

          V is the volume of the gas

         n is the number of moles

         R is the gas constant

         T is the temperature of the gas

Let us convert to appropriate units;

      1000°C to K;

       K  = 1000 + 273  = 1273K

100000Pa to atm;

           101325Pa  = 1atm

           100000Pa = 0.99atm

 Input the parameters and solve for the unknown;

      0.99 x V  = 2 x 0.082 x 1273

                   V  = 210.9dm³

to m³;

        1000dm³   = 1m³

        210.9dm³ = [tex]\frac{210.9}{1000}[/tex]   = 0.21m³