6. Which statement best describe the relationship between temperature and thermal energy?
(1 Point)
Temperature is inversely related to thermal energy
Temperature is directly proportional to thermal energy
As temperature foes up, thermal energy goes down
Thermal energy is not related to energy

Answer:

1. 7

2. Mass

3. (b) Distance

4. (b) Force

5. (a) ML⁻¹T⁻²

6. (c) M⁻¹LT²

7. (c) M⁻¹L³T⁻²

8. (c) Pressure

9. (c) Young's modulus

10. (b) zero

11. (c) Infinite

12. (d) 1:4

13. (b) 0.6 J

14. (c) 45 N

15. (a) 0.4 cc

16. (a) 176.7 °F

17. (a) 10°C

18. (c) 50 K

19. b. H

Explanation:

15. Whereby the compressibility = 4 × 10⁻⁵ Pa⁻¹

The compression ratio for 100 Pa = 4 × 10⁻⁵ × 100 = 4 × 10⁻³

The Change for 100 cc = 4 × 10⁻³ × 100 cc = 0.4cc

Answer:

metamorphic rock

Explanation:

Igneous rocks can be changed into metamorphic rocks when heat and pressure are applied to the rock.

Pressure and heat in the presence of a fluid phase cause metamorphic transformation of a prolith.

Through heat and pressure, igneous rocks can be transformed into metamorphic rocks.  

Answer:

classic sedimentary rock

Explanation:

Answer:

Explanation:

The momentum of an object can be found by using the formula

From the question

mass = 950 kg

velocity = 10.0 m/s

We have

momentum = 950 × 10

We have the final answer as

Hope this helps you

Answer:

Explanation:

1.wrap bar magnet in a plastic baggie and remove the iron filings from the mixture by using a bar magnet. Place a small piece of scrap paper on the scale and “tare” the scale. Then place filings on the scrap paper and record (e) the mass of the iron filings. Don't throw out the iron–save it to be recollected.

2.When sand is added to water it either hangs in the water or forms a layer at the bottom of the container. Sand therefore does not dissolve in water and is insoluble. It is easy to separate sand and water by filtering the mixture. Salt can be separated from a solution through evaporation.

3.Sand (mostly silicon dioxide) is not.

Pour the salt and sand mixture into a pan.

Add water. ...

Heat the water until the salt dissolves. ...

Remove the pan from heat and allow it to cool until it's safe to handle.

Pour the salt water into a separate container.

Now collect the sand.

Pour the salt water back into the empty pan.

Heat the salt water until the water boils. Continue boiling it until the water is gone and you're left with the salt.

Another way you can separate the salt water and sand is to stir up the sand/salt water and pour it through a coffee filter to capture the sand.

Answer:

1. Separating iron from mixture

2. Separating sand from mixture

3. Separating Salt mixture

Answer:

none of the answers are correct

Explanation:

Lithium = 3

Berillium = 4

Boron = 5

Carbon = 6

Answer:

yes

Explanation:

Answer: True

Im sure of it i took the test

Explanation:

Answer:

Force = Mass * Acceleration

Explanation:

24*1.74= 42 N

Given parameters:

Acceleration of the car = 1.6m/s

Initial speed  = 80km/hr

Final speed  = 110km/hr

Solution:

Time taken to achieve this speed = ?

Solution:

Acceleration is the rate of change of velocity with the time taken.

  Mathematically;

     a  = [tex]\frac{V - U}{T}[/tex]

where a is the acceleration

           V is the final velocity

           U is the initial velocity

           T is the time taken

Now make the unknown time the subject of the expression;

      aT  = V - U

         T = [tex]\frac{V - U}{a}[/tex]  

Convert the given acceleration to km/hr;

       1.6m/s  = 1.6 x [tex]\frac{m}{s}[/tex]  x [tex]\frac{1km}{1000m}[/tex] x [tex]\frac{3600s}{1hr}[/tex] = 5.76km/hr

Input the parameters and solve;

       T = [tex]\frac{110 - 80}{5.76}[/tex]  = 5.2hrs

The time taken is 5.2hrs

Answer: tug vi

Explanation:

Because

Answer:

i think its 2.0

Explanation:

hopefully i am right ...

Answer:It's B energy is absorbed by the reaction,hope this helps

Explanation:

Any reaction in which energy is absorbed is said to be endothermic. Hence, option B is correct, but the rest are not correct.

In every chemical process, energy is involved. When new bonds form in products, energy is produced. Reactant bonds are broken using energy. Exothermic reactions are those that produce more energy when new bonds form in the products than is needed to break existing bonds in the reactants.

In contrast, endothermic reactions are the opposite. Endothermic reactions release more energy when new bonds form in the products than is required to break bonds in the reactants.

During the reaction, a large amount of energy is absorbed.

To get more information about Endothermic Reaction :

https://brainly.com/question/23184814

#SPJ5

Answer:

i put cereal first

Explanation:

cereal

This is how you calculate his speed, for the 100metres. That is, the average speed for the entire distance, including the start from intertia until the race end where the athlete is decelerating. Multiply the time by 10, and divide 3600 by that figure. i.e. 10 by10 equals 100. Divide 3600 by 100 and you get 36 which is the speed figure you requested.

A female athlete ran 200 metres a few years ago and in the middle section of the race covered 100 metres in that race in a time under 10 seconds. That is, she ran a sub 10second 100metres from a flying start. This great athlete from Slovenia, also ran a 100 metre race (from a stationary start) in a time under 11 seconds, when she was 48 years of age. Her name is Merlene Ottey.

Answer:

Distance, S = 108 meters.

Explanation:

Force is given by the multiplication of mass and acceleration.

Mathematically, Force is;

[tex] F = ma[/tex] ............equation 1

Where;

Given the following data;

Since the boat is starting from rest, initial velocity, u = 0

Mass, m = 600kg

Time, t = 12s

Force, F = 900N

Substituting into equation 1, we have;

[tex] 900 = 600*a[/tex]

[tex]a = \frac{900}{600}[/tex]

Acceleration, a = 1.5 m/s²

T

To solve for distance, we would use the second equation of motion;

[tex] S = ut + \frac {1}{2}at^{2}[/tex]

Substituting the values into the equation, we have;

[tex] S = 0(12) + \frac {1}{2}*1.5* 12^{2}[/tex]

[tex] S = 0 + 0.75* 144[/tex]

Distance, S = 108m

Therefore, the distance covered by the boat is 108 meters.

Answer:

B and D

Explanation:

Did the quiz

Electromagnetic waves require no wires to carry information and can travel through either air or other types of matter.​ Therefore, options (B) and (D) are correct.

Electromagnetic radiations are produced when an electric field comes in contact with the magnetic field. Electromagnetic waves are the composition of oscillating electric as well as magnetic fields.

Infrared radiation is used in security cameras and used for night vision. UV rays are useful to detect forged banknotes as the real banknotes don’t turn fluorescent under UV light.

Electromagnetic radiation can travel energy in a vacuum or air. Electromagnetic waves play a vital role in today's communication technology. Electromagnetic waves are specially used in RADARS to detect aircraft in the earth's atmosphere.

Radio waves, microwaves, infrared (IR), and visible light can be used for communication. Radio waves are used to transmit information on television and radio programs. Microwaves are used to transmit satellites, mobile phones, and television.

Learn more about the electromagnetic wave, here:

https://brainly.com/question/3001269

#SPJ5

Answer:

density = [tex]\frac{mass}{volume}[/tex]

so,

     d = 2/0.00025

     d = 8000 kg/m3

Answer:

friction, should be correct i think!

Answer:

The work done will be 0.115 J.

Explanation:

Given that,

[tex]k=100\ N/m[/tex]

[tex]b=700\ N/m^2[/tex]

[tex]c=12000\ N/m^3[/tex]

A force along the x-axis with x-component,

[tex]F(x)=kx-bx^2+cx^3[/tex]

Suppose, How much work must be done to stretch this spring by 0.050 m from its unstretched length?

We need to calculate the work done

Using formula of work done

[tex]W(x)=\int{F(x)dx}[/tex]

Put the value into the formula

[tex]W(x)=\int{(kx-bx^2+cx^3)dx}[/tex]

[tex]W(x)=\dfrac{kx^2}{2}-\dfrac{bx^3}{3}+\dfrac{cx^4}{4}[/tex]

Put the value of k,b,c and x

[tex]W(0.050)=\dfrac{100\times(0.050)^2}{2}-\dfrac{700\times(0.050)^3}{3}+\dfrac{12000\times(0.050)^4}{4}[/tex]

[tex]W(0.050)=0.115\ J[/tex]

Hence, The work done will be 0.115 J.

The value of spring displacement is greater than zero. Therefore, spring is stretched.

  It is given as,  [tex]F=kx[/tex]

Where k is constant and x is amount of displacement.

The force function is given that,

       [tex]F(x)=kx-bx^{2}+cx^{3}[/tex]

Here given that,  [tex]k=100N/m, b=700N/m^{2} , c=12000N/m^{3} .[/tex]

Substitute all values in above equation,

           [tex]F(x)=100x-700x^{2} +12000x^{3}[/tex]

To check, the spring is stretched or it is compressed.

Substitute f(x) = 0

          We get x is greater than zero.

Thus, The value of spring displacement is greater than zero. Therefore, spring is stretched.

Learn more about the spring force here:

https://brainly.com/question/14970750

Answer:  The 7.3 earthquake carries more energy

Explanation:

Because, it has a higher amplitude

Answer: malleability

Explanation:

Answer:

a = 10/s^2

Explanation:

Answer:

a=10 m/s *2 right

Explanation:

The net force (0.5 kg) divided by the mass (5 N) = 10

The force moved the object to the right.

So you Would put this in the equation a=___ m/s *2 _____

And you would get a=10m/s*2 right

HOPE YOU LEARNED SOMETHING SO WHEN WE GO BACK TO SCHOOL YOU WILL KNOW WHAT YOU ARE TALKING ABOUT ! : )

Answer:

In space noone can hear you scream.....

Explanation:

There is no sound in space. Sound, like light or heat, is a wave. However, one major distinction is that, unlike light or heat (radiation), sound needs a medium to travel. Sounds require the presence of molecules or particles to travel from one region to another.

Explanation:

Work=ForcexDisplacement

Force= Work/Displacement

= 1300/40

= 32.5 N