A plastic rod is rubbed with a cloth and becomes positively charged. After charging, the rod is held close to the suspended table-tennis ball shown in Fig. 9.1. The table-tennis ball is covered with metal paint and is uncharged.


Describe what happens to the charges on the metal-painted table-tennis ball as the positively-charged rod is brought close to the ball.

Answer:

B and C is the Answer

Follow me please

Mark brainliest

Answer:

The building are not getting farther and farther away, road signs, exits, other cars

Explanation:

Answer:

1. Mike was riding in the wagon when it had the most acceleration because his light weight compared to Tim's weight required the least effort to move

2. Mike

Explanation:

According to Newton's second law of motion, force is proportional to te rate of change of momentum produced

Mathematically, we can write the above law as follows;

F = m × a

Where;

F = The force acting on the object

m = The mass of object in motion

a = The acceleration of the object

1. The given parameters in the question are;

The weight of Tim = 311 Newtons (70 lbs.)

The weight of Mike = 50 Newtons (50 lbs.)

The minimum force required to pull the wagon to constant speed = The weight of the wagon

With the assumption that the wagon has very little weight, we have

Therefore, when Tim gets in the wagon, the force, 'F' applied by Mike to pull the wagon to constant speed = Mass of Tim, m × Acceleration of the cart, a

Given that mass is proportional to weight, we can write;

Force from mike, Tim on the wagon F₁ = 311 N × a₁

Similarly when they switched places, we have;

Force from Tim, Mike on the wagon  = F₂ = 50 N × a₂

Therefore, for the same force, F₁ = F₂ = F, we have;

a₁ = F₁/(311 N) = F/(311 N)

a₂ = F₂/(50 N) = F/(50 N)

By fraction of numbers, F/(50 N) > F/(311 N) > N), therefore, a₂ > a₁

The acceleration of the wagon when Mike was on the wagon will be more than the acceleration of the wagon when Tim gets in the wagon because for the same applied force, the weight of Mike offer less resistance to move

2. Given that Sare and Mike have the same weight of 50 N each let F₃ represent the force with which she pulls Mike in the wagon, and F₁ represent the force with which Mike pulls her while she is on the wagon, we  are also given that F₃ > F₁

By Newton's second law of motion, we have;

a₃ = F₃/(50 N) and a₁ = F₁/(50 N)

From F₃ > F₁, we have;

F₃/(50 N) > F₁/(50 N)

Therefore;

a₃ > a₁

The acceleration of the wagon when Mike is being pulled by Sare, a₃, is greater than the acceleration of the wagon when Sare is pulled by Mike

Therefore, Mike is on the wagon when it has the greatest acceleration.

Answer:

germ cleaning

and getting up cooking grease

Explanation:

Answer:

[tex]1311.5\ \text{Nm}[/tex]

Explanation:

l = Length of ladder = 8.57 m

m = Mass of ladder = 21.4 kg

F = Force on ladder = 258 N

[tex]\alpha[/tex] = Angular acceleration = [tex]1.63\ \text{rad/s}^2[/tex]

g = Acceleration due to gravity = [tex]9.81\ \text{m/s}^2[/tex]

Net torque is given by

[tex]\tau=lf-\dfrac{l}{2}mg\\\Rightarrow \tau=8.57\times 258-\dfrac{8.57}{2}\times 21.4\times 9.81\\\Rightarrow \tau=1311.5\ \text{Nm}[/tex]

The net torque acting on the ladder is [tex]1311.5\ \text{Nm}[/tex].

Answer:

24 hours. 365 days

Explanation:

The molecules move from one side to another across the concentration gradient by breaking weaker bonds among the atom into stronger bonds. This is done to decrease the overall kinetic energy to become a more stable molecule.

The kinetic strength of the molecules consequences in random movement, causing diffusion. In simple diffusion, this method proceeds without the useful resource of a transport protein. it is the random motion of the molecules that reasons them to move from a place of excessive attention to a place with decreased awareness.

The molecules in a gas, a liquid, or a strong are in consistent movement due to their kinetic electricity. Molecules are in steady movement and collide with each different. those collisions cause the molecules to move in random guidelines. over time, however, greater molecules may be propelled into the less concentrated place.

The majority of the molecules flow from better to decrease awareness, although there can be some that circulate from low to excessive. the general (or net) motion is consequently from high to low concentration.

Learn more about molecules here:-https://brainly.com/question/26044300

#SPJ1

Answer:

445N

Explanation:

F=mg

m=44.5kg

g=10m/s2

F=44.5 * 10

=445N

Iron ( Fe ) is a micro element that is essential for the formation of haemoglobin.

Hemoglobin has two components-

Answer:

v = 17.30 m / s

Explanation:

For this exercise we will use Newton's second law

at the bottom of the loop and stopped

           ∑ F = 0

           N-W = 0

           N = W

            W = 770 N

the mass of the body is

            W = mg

             m = W / g

            m = 770 / 9.8

            m = 78.6 kg

on top of the loop and moving

           ∑ F = m a

           N + W = m a

note that the three vectors go in the same vertical direction down

the centripetal acceleration is

           a = v² / r

we substitute

           N + W = m v² / r

           v = [tex]\sqrt{(N+W) \frac{r}{m} }[/tex]

let's calculate

          v = [tex]\sqrt{ (350+770) \frac{21}{78.6} }[/tex]

          v = 17.30 m / s

Answer:

what is your exact question.

Explanation:

Frictional force causes a lot of losses in general upkeep and wear and tear of machinery. Hence it is considered as a evil. But almost all crucial tasks cannot be carried out without the presence of friction. ... Hence it is considered as a necessary evil .

Explanation:

Frictional force causes a lot of losses in general upkeep and wear and tear of machinery. Hence it is considered as a evil. But almost all crucial tasks cannot be carried out without the presence of friction. ... Hence it is considered as a necessary evil .

Answer:

vz vc

Explanation:

v b

Answer:

Wavelength of light in  diamond λ2 = 179.75 nm (Approx.)

Explanation:

Given:

Blue light of wavelength λ1 = 435 nm

n2 in diamond = 2.42

Find:

Wavelength of light in  diamond λ2

Computation:

Since the wavelength is smaller, the frequency stays constant. The frequency of vibrations does not shift when they pass from one source to the next.

So,

n1λ1 = n2λ2

(1)(435) = (2.42)λ2

Wavelength of light in  diamond λ2 = 179.75 nm (Approx.)

Answer:

180

Explanation:

got it right on acellus

Answer:

40 Kpa

Explanation:

150 cm2 = 0.015 m2

[tex]p \: = \frac{mg}{ a} = 40000[/tex]

Answer:

B The resultant force on the satellite is towards the Earth.

Explanation:

In the case when the satellite orbits earth would be at constant speed in the circular orbit so hee the resultant force that on the satellite would be with regard to the earth

So as per the given situation, the option B is correct

And, the rest of the options would be wrong

And, the same would be relevant

Answer:

0.19 and 0.45

Explanation:

edge

The first and second velocities of the car are [tex]0.25/t_1[/tex] and [tex]0.50/t_2[/tex]respectively.

The velocity of an object is defined as the product of the distance travelled in a given direction and the time required to travel that distance. The velocity is expressed mathematically as,

v = d/t

Here, d represents the travelled distance.

And t is the typical amount of time needed to go the distance.

Given,

The value of the first distance is, d1 = 0.25 m.

The value of the second distance is, d2 = 0.50 m.

Then the first velocity of the car at 0.25 m is,

[tex]v_1 = d_1/t_1\\v_1 = 0.25 / t_1[/tex]

Thus,[tex]t_1[/tex] denotes the first distance's typical time.

The second velocity of the car with three washers at the 0. 50 m mark is

[tex]v_2 = d_2/t_2\\v_2 = 0.50 /t_2[/tex]

Here, [tex]t_2[/tex] stands for the second distance's typical time.

Thus, the first and second velocities of the car are [tex]0.25/t_1[/tex] and [tex]0.50/t_2[/tex]respectively.

Learn more about Velocity, here:

brainly.com/question/25796948

#SPJ2

Answer:

86.5 m

Explanation:

[tex]s = ut + \frac{1}{2} at {}^{2} \\ s = (0)(4.2) + \frac{1}{2} (9.81)(4.2) {}^{2} \\ s = 86.5m [/tex]

Answer:

86.5 m

Explanation:

Answer:

Thrust = 200 N

Explanation:

The engine thrust can be found by using the following formula:

[tex]Thrust = mv[/tex]

where,

m = mass flow rate of the fuel = 0.05 kg/s

v = velocity of ejected gases = 4000 m/s

Therefore, using the given values in the equation, we get:

[tex]Thrust = (0.05\ kg/s)(4000\ m/s)[/tex]

Thrust = 200 N

Answer:

A

Explanation:

I took the test

Answer:

The reason why one cannot hear in space but light can be seen is because light and sound are different kinds of wave

Light is an electromagnetic wave that propagates by a changing magnetic field hat creates a changing electric field. Light is created by a vibrating electric charge, and is transmitted through a medium by the absorption and reemission of the light by the medium particles

Sound is a longitudinal mechanical wave that is propagated by the vibration of the particles of the medium.

Sound requires a medium to propagate and it cannot be propagated or heard through space which is a vacuum.

Sound is created by a source that is vibrating and the vibration is transmitted to particles in the medium including solids, liquids, gases and plasma that the vibrating energy is in direct contact with and the transfer of the sound energy continues between layers of adjacent particles for the medium for the sound to be propagated from place to place

Explanation:

Answer:

 m = 4.0

Explanation:

For this exercise in geometric optics we will use the equation of the constructor

         [tex]\frac{1}{f} = \frac{1}{p} + \frac{1}{q}[/tex]

where f is the focal length, p and q are the distance to the object and image, respectively.

In the exercise indicate the focal length f = 2.00 cm, the distance to the object p = 1.60 cm, let's find the distance to the image

         [tex]\frac{1}{q} = \frac{1}{f} - \frac{1}{p}[/tex]

let's calculate

         [tex]\frac{1}{q} = \frac{1}{2} - \frac{1}{1.6}[/tex]1 / q = ½ - 1 / 1.6

         [tex]\frac{1}{q}[/tex] = -0.125

         q = -8 cm

the magnification is

        m = - q / p

        m = 8/2

        m = 4.0

Answer:All the forces are acting. The force due to which the car stops that is between road and tire is "friction".

Explanation:

Answer:

They do that by converting rotating mechanical energy into electrical power. Portable generators use an engine—typically running on gasoline, diesel, or propane, to turn an alternator which produces alternating electrical current or AC.

Answer:

C. Elements with intermediate number of valence electrons are the most chemically stable.

Answer:

surface tension

Explanation:

because of surface tension in water

Answer:

The name given to the underwater mountains in the middle of oceans is;

Mid-ocean ridges

Explanation:

Mid-ocean ridges, also known as mid-oceanic ridge is a mountain range made by plate tectonics under the water.

The magma created at a divergent boundary where two tectonic plates meet due to the rise of convection currents in the Earth's mantle which is beneath the oceanic crust results in the uplifting of the ocean floor.

Answer:

The acceleration of the object is -29.12 m/s².

Explanation:

The acceleration of the object can be calculated by Newton's second law:

[tex] \Sigma F = ma [/tex]

[tex] - F - F_{\mu} = ma [/tex]                        

[tex] - F - \mu mg = ma [/tex]                        

Where:

F: is the applied force = 40.0 N

μ: is the coefficient of kinetic friction = 0.25

m: is the mass of the object = 1.5 kg

g: is the acceleration due to gravity = 9.81 m/s²

a: is the acceleration =?

[tex] a = \frac{- F - \mu mg}{m} = \frac{-40.0 N - 0.25*1.5 kg*9.81 m/s^{2}}{1.5 kg} = -29.12 m/s^{2} [/tex]

The minus sign is because means that the object is decelerating due to the applied force and the friction.  

Therefore, the acceleration of the object is -29.12 m/s².

I hope it helps you!