Answer:
17.8954903 or 17.9 mph
Explanation:
m/s is meters per second. 1609.344 meters is one mile. There are 3,600 seconds in an hour. 8 meters *3600 seconds= 28,800. 28,800/1609.344 = 17.8954903. Simplify to 17.9
What is electromagnetic wave ?
its an electric magnetic cell this uses electricity
please help asap!!!!!!!!!!!
A car weighing 8000N is traveling at 45 m/s on a perfectly flat, frictionless road. If the driver slams on the brakes, how far will thw car slide before it comes to a stop?
Without friction, the car cannot stop...
How much energy is needed just to boil 5kg of water at 100◦ C?
Read the picture, please. I am a bit confused about what it means when it says which one supports it.
Answer:
not suppoted
not supported
support
In a car engine, fuel is ignited within a cylinder to cause an explosion that moves a piston. If the explosion exerts 300 Pa of pressure on a piston with a surface area of 80 cm^2?
The force exerted by the explosion on the piston is 2.4 N.
The given parameters:
Pressure of the explosion on piston, P = 300 Pa (N/m²)Surface area of the piston, A = 80 cm²The force exerted on the piston by the explosion is calculated as follows;
F = PA
where;
A is the area of the piston in m²
The surface area of the piston in square meter is calculated as follows;
[tex]A = 80 \ cm^2 \times \frac{(1m)^2}{(100 \ cm)^2} \\\\A = 0.008 \ m^2[/tex]
The force exerted by the explosion on the piston is calculated as follows;
[tex]F = 300 \ (N/m^2)\ \times \ 0.008 \ (m^2)\\\\F = 2.4 \ N[/tex]
The complete question is here:
In a car engine, fuel is ignited within a cylinder to cause an explosion that moves a piston. If the explosion exerts 300 Pa of pressure on a piston with a surface area of 80 cm^2, what is the force exerted on the piston?
Learn more about force and pressure here: https://brainly.com/question/22930937
Describe when the chemical
reaction occurs in a dry-cell
battery
Answer:
For a dry-cell battery to operate, oxidation will occur from the zinc anode and reduction will take place in the cathode. The most common type of cathode is a carbon graphite. Once reactants have been turned into products, the dry-cell battery will work to produce electricity.
Explanation:
The battery operates through electrochemical reactions called oxidation and reduction. These reactions involve the exchange of electrons between chemical species. If a chemical species loses one or more electrons, this is called oxidation. The opposite process, the gain of electrons, is called reduction.
A car that's initially traveling at 10 m/s acceleration uniformly for 4 seconds at a rate of 2 m/s?in a straight line. How far does the car travel during this time?
Answer:
Explanation:
The answer is -2m/s²
An object, initially at rest, moves 475 m in 19 s. What is its acceleration? *
[tex]\\ \sf\Rrightarrow s=ut+\dfrac{1}{2}at^2[/tex]
[tex]\\ \sf\Rrightarrow s=0(19)+\dfrac{1}{2}a(19)^2[/tex]
[tex]\\ \sf\Rrightarrow 475=\dfrac{361a}{2}[/tex]
[tex]\\ \sf\Rrightarrow 950=361a[/tex]
[tex]\\ \sf\Rrightarrow a\approx 2.3m/s^2[/tex]
A log has a density of. 8 g/cmÂł. What will happen to this log in freshwater, which has a density of 1. 0 g/cmÂł? It will sink. It will float. It will move deeper. It will decrease in density.
When a log of wood is put over the freshwater, the log start to float. Option B is correct.
Density:
It can be defined as the amount of substance per unit volume. It is usually denoted by D. It is measured in the [tex]\bold { kg/m^3}[/tex].
The less dense object always floats over the more dense substance.
For example- Here, The density of the log is 0.8 [tex]\bold{ cm^3}[/tex] and the density of the of water is 1.0 [tex]\bold{ cm^3}[/tex] .
Since, the density of the log is lesser than the density of the water.
Therefore, when a log of wood is put over the freshwater, the log start to float.
To know more about Density:
https://brainly.com/question/952755
What is the sum of 130+125+191? A. 335. B. 456. C. 446. D. 426.
If we minus 712 from 1500, how much do we get? A. 788. B. 778. C. 768. D. 758.
50 times of 8 is equal to: A. 80. B. 400. C. 800. D. 4000.
110 divided by 10 is: A. 11. B. 10. C. 5. D. None of these.
FRIEND ME!!!
Above sea level, water boils at a __ temperature due to the __ atmospheric pressure.
Answer:
lower, lower
Explanation:
When atmospheric pressure is lower, such as at a higher altitude, it takes less energy to bring water to the boiling point. Less energy means less heat, which means water will boil at a lower temperature at a higher altitude.
Draw a diagram that represents how a mechanical wave interacts with a particular material.
Create a diagram and include reflection, absorption, and transmission.
Write a brief description (3+ sentences) of the interaction of the mechanical waves and the material. Include an explanation of how the amplitude and frequency of the wave are affected.
85 POINTS!!
When mechanical waves interact with material, it transfer its energy to the material.
What are mechanical waves?Mechanical waves are the type of waves that require a medium for transporting their energy from one region to another. Mechanical waves depend on particle interaction in order to transport their energy.
The amplitude and frequency of the wave are negatively affected due to the striking of mechanical waves with the material.
Learn more about waves here: https://brainly.com/question/75996
Answer:
i have a screenshot just use mine https:/ss27
Explanation:
pls help me, its just fill in the blank
1. Frequency
2. Reflected
3. Absorbed
4. Black
A baseball player at practice is pushing a tackling dummy across the field. He initially has to push the 130 kg dummy with 600 Newton’s of force to get it to start moving and maintain a force of 475 to keep it moving at a steady state. What are the coefficient of friction static and kinetic with the dummy on the ground
.
Answer:
Static= 600/(130*9.8)=0.47
Kinetic=475/(130*9.8)=0.37
The power ratings of several motors are listed in the table. A 2 column table with 3 rows. The first column is labeled motor with entries, brand X, brand Y, brand Z. The second column is labeled Power in watts with entries 7460, 7650, 7580. An advertising agency writes marketing material for a new motor (Brand W) that has a power rating of 7,640 W. Which statement comparing the motors can they truthfully use? Brand W motor can finish any job faster than Brand Y motor can. There’s not a more powerful motor available. Brand W motor does more work each second than Brand X or Brand Z. Every second, Brand W motor does 7,640 N of your toughest work.
The statement " Brand-W motor does 7,640 N of your toughest work." can be truthfully use.
Advertisement Rules:
An advertiser can not compare its products using the other companies name.An advertiser can not make the false statement in its advertisement.Here, the brand-W has the power rating of 7,640 W that is less than brand-Y. Advertiser cannot compare his brand using the name of Brand X, Y, or Z.
Therefore, the statement " Brand-W motor does 7,640 N of your toughest work." can be truthfully use.
To know more about Advertisement Rules:
https://brainly.com/question/13679377
Answer:
The correct answer is C, Brand W motor does more work each second than Brand X or Brand Z.
PLEASEE IS FOR A TEST!!!Which ionic compound is BOTH correctly written and named??
A mg0 magnesium oxide
B Mn02 manganese oxide
C N02 nitrogen oxide
D SrBr strontium bromide
Answer:
Letter A
Explanation:
Manganese dioxide- Mn02
Nitrogen Dioxide- n02
Strontium bromide- SrBr
do we use more freshwater in our homes to provide us with electricity
Answer:
No. Water can be used in a hydroelectric dam to generate electricity, but this does not make us use more or less water in our homes.
Explanation:
Answer:We use more freshwater to provide us with electricity. Water is the only compound that can be found naturally as a liquid, gas, and solid.
Explanation:
Can we get less ads please i don’t like this
How can you decrease the amount of input force of a wheel and axle?
Explanation:
hmm by the increasing the size of wheel and decreasing axle
During chemical reactions, bonds between atoms break and form. What does this mean in terms of subatomic particles? (1 point)
O Electrical fields of charged particles interact, bonding those with the same charge.
Electrical fields of neutral particles interact, bonding those with opposite charges.
O Electrical fields of neutral particles interact, bonding those with the same charge.
o Electrical fields of charged particles interact, bonding those with opposite charges
During chemical reactions, bonds between atoms break and form Electrical fields of charged particles interact, bonding those with opposite charges.
What is the chemical bonds?During chemical reactions, bonds between atoms break and form Electrical fields of charged particles interact, bonding those with opposite charges.
Since we know that every element have electrons in their atoms and every atom have vacant shells.
So during chemical reactions the elements fulfill their vacant shells and form bonds between each other it can be ionic or it can be covalent bond.
But when atoms breaks the bond their will be the positively or negatively charged electrons left in the atoms.
Hence During chemical reactions, bonds between atoms break and form Electrical fields of charged particles interact, bonding those with opposite charges.
To know more about chemical bonds follow
https://brainly.com/question/819068
Why don't atoms get too close?
a.) The electrons from atom repel each other
b.) The protons from each atom repel each other
c.) The neutrons from each atom repel each other
Answer:
This tends not to happen, because atoms are composed of charged particles that interact at a distance. ... Since the electrons are around the outside of the atom, those are the things that first interact, and as they have the same charge, they repel one another.A. The electrons from atom repel each other
A gas in a closed container is heated with 10J of energy, causing the lid of the container to rise 2m with 3N of force. What is the total change in energy of the system
Explanation:
For this problem, use the first law of thermodynamics. The change in energy equals the increase in heat energy minus the work done.
ΔU=Q−W
We are not given a value for work, but we can solve for it using the force and distance. Work is the product of force and displacement.
W=FΔx
W=3N×2m
W=6J
Now that we have the value of work done and the value for heat added, we can solve for the total change in energy.
ΔU=Q−W
ΔU=10J−6J
ΔU=4J
Answer is 4J
i think this may help you very much
A(n) 1700 kg car is moving along a level road at 21 m/s. The driver accelerates, and in the next 10 s the engine provides 22000 J of additional energy. If 3666.67 J of this energy must be used to overcome friction, what is the final speed of the car
The final speed of the car at the given conditions is 30.1 m/s.
The given parameters:
Mass of the car, m = 1700 kgVelocity of the car, v = 21 m/sTime of motion, t = 10 sAdditional energy provided by the engine, E₁ = 22,000 JEnergy used in overcoming friction, E₂ = 3,666.67 JThe change in the energy applied to the car is calculated as;
[tex]\Delta E = E_1 - E_2\\\\\Delta E = 22,000 \ J \ - \ 3,666.67 \ J\\\\\Delta E = 18,333.33 \ J[/tex]
The final speed of the car is calculated as follows;
[tex]\Delta E = \frac{1}{2} m(v_f^2 - v_0^2)\\\\v_f^2 - v_0^2 = \frac{2\Delta E}{m} \\\\v_f^2 = \frac{2\Delta E}{m} + v_0^2\\\\v_f = \sqrt{ \frac{2\Delta E}{m} + v_0^2} \\\\v_f = \sqrt{ \frac{2\times 18,333.4}{1700} + (21)^2} \\\\v_f = 30.1 \ m/s[/tex]
Thus, the final speed of the car at the given conditions is 30.1 m/s.
Learn more about change in kinetic energy here: https://brainly.com/question/6480366
Fill in the blanks about Newton’s First Law of Motion:
Objects want to ____________ ____________ doing what they’re ____________ ____________ because they are “lazy.” This is called ____________.
Objects want to continue doing what they’re doing because they are “lazy.” This is called law of inertia.
Newton's first law of motion states that an object at rest or uniform motion in a straight line will continue in that state unless it is being acted upon by an external force. This law is also called the law of inertia because it depends on mass.
From the given question, we can fill gaps as follows;
Objects want to continue doing what they’re doing because they are “lazy.” This is called law of inertia.
Learn more about Newton's first law of motion here: https://brainly.com/question/10454047
What is science notation
Answer:
Scientific notation is the way that scientists easily handle very large numbers or very small numbers. For example, instead of writing 0.0000000056, we write 5.6 x 10-9. So, how does this work? We can think of 5.6 x 10-9 as the product of two numbers: 5.6 (the digit term) and 10-9 (the exponential term).
Explanation:
desventajas de la fricción cinética
Answer:
Please translate this into Spanish! Sorry I can't :(
Explanation:
Disadvantages of Friction:
Friction produces unnecessary heat leading to the wastage of energy.
The force of friction acts in the opposite direction of motion, so friction slows down the motion of moving objects.
Forest fires are caused due to the friction between tree branches.
Make a super villain out of these resources
Answer:the super villain would have the ability to control electricity and could take any Metal object or weapons that anyone points at him because he is magnetic
Explanation:
What is the relationship between momentum and speed?
Answer:
Momentum is directly proportional to the object's mass and also its velocity.
Explanation:
Thus the greater an object's mass or the greater its velocity, the greater its momentum. Momentum p is a vector having the same direction as the velocity v.
Help if u can please
Answer:
d
Explanation: