Answers
Answer:
no work is done cause there is no movement of the wall
Related Questions
Which of the following happens to
density as air pressure decreases?
С C
A. Density increases.
B. Density stays the same.
C. Density decreases.
D. There is no correlation between air pressure and
density.
Answers
Explanation:
As pressure increases, with temperature constant, density increases. Conversely when temperature increases, with pressure constant, density decreases. Air density will decrease by about 1% for a decrease of 10 hPa in pressure or 3 °C increase in temperature.
How would increasing the pressure of this reaction affect the equilibrium
Answers
Explanation:
c because there is element
Answer:
C. H2 and N2 would react to produce more NH3
Explanation:
A.P.E.X
What causes the Coriolis effect?
A
The sun's position relative to Earth
B.
Earth's orbit around the sun
с
Moon phases
D
Earth's rotation
Answers
A 2.0 kg breadbox on a fric-
tionless incline of angle u 40 is
connected, by a cord that runs over a
pulley, to a light spring of spring con-
stant k 120 N/m, as shown in
Fig. 8-43. The box is released from rest when the spring is unstretched. Assume that the pulley is massless and frictionless. (a) What is the speed of the box when it has moved 10 cm down the in- cline? (b) How far down the incline from its point of release does the box slide before momentarily stopping, and what are the (c) magnitude and (d) direction (up or down the incline) of the box’s acceleration at the instant the box momentarily stops?
Answers
A wave has a wavelength of 1.5 meters and period of 0.083s. What is the waves speed?
Answers
What is the order of the events for the water cycle on a typical warm day?
А
rain, snow, sleet
B
precipitation, evaporation, rain
с
evaporation, condensation, precipitation
D
condensation, evaporation, precipitation
Answers
A 20 ft ladder leans against a wall. The bottom of the ladder is 3 ft from the wall at time t=0 and slides away from the wall at a rate of 2ft/sec. Find the velocity of the top of the ladder at time t=1.
Answers
Answer: 0.516 ft/s
Explanation:
Given
Length of ladder L=20 ft
The speed at which the ladder moving away is v=2 ft/s
after 1 sec, the ladder is 5 ft away from the wall
So, the other end of the ladder is at
[tex]\Rightarrow y=\sqrt{20^2-5^2}=19.36\ ft[/tex]
Also, at any instant t
[tex]\Rightarrow l^2=x^2+y^2[/tex]
differentiate w.r.t.
[tex]\Rightarrow 0=2xv+2yv_y\\\\\Rightarrow v_y=-\dfrac{x}{y}\times v\\\\\Rightarrow v_y=-\dfrac{5}{19.36}\times 2=0.516\ ft/s[/tex]
Which of the following actions will increase the current induced in a wire by a
magnetic field?
Answers
Answer:
The induced current can be increased in the coil in the following ways: By increasing the strength of the magnet. By increasing the speed of the magnet through the coil.
Explanation:
A scientist notices that an oil slick floating on water when viewed from above has many different colors reflecting off the surface, making it look rainbow-like (an effect known as iridescence). She aims a spectrometer at a particular spot and measures the wavelength to be 750 nm (in air). The index of refraction of water is 1.33.
Part A: The index of refraction of the oil is 1.20. What is the minimum thickness of the oil slick at that spot? t= 313nm
Part B: Suppose the oil had an index of refraction of 1.50. What would the minimum thickness be now? t=125nm
Answers
Answer:
a) The minimum thickness of the oil slick at the spot is 313 nm
b) the minimum thickness be now will be 125 nm
Explanation:
Given the data in the question;
a) The index of refraction of the oil is 1.20. What is the minimum thickness of the oil slick at that spot?
t[tex]_{min[/tex] = λ/2n
given that; wavelength λ = 750 nm and index of refraction of the oil n = 1.20
we substitute
t[tex]_{min[/tex] = 750 / 2(1.20)
t[tex]_{min[/tex] = 750 / 2.4
t[tex]_{min[/tex] = 312.5 ≈ 313 nm
Therefore, The minimum thickness of the oil slick at the spot is 313 nm
b)
Suppose the oil had an index of refraction of 1.50. What would the minimum thickness be now?
minimum thickness of the oil slick at the spot will be;
t[tex]_{min[/tex] = λ/4n
given that; wavelength λ = 750 nm and index of refraction of the oil n = 1.50
we substitute
t[tex]_{min[/tex] = 750 / 4(1.50)
t[tex]_{min[/tex] = 750 / 6
t[tex]_{min[/tex] = 125 nm
Therefore, the minimum thickness be now will be 125 nm
would it be m/s or kg?
Answers
Answer:
m.s
Explanation:
What is the unit of measurement of mass and weight?
Answers
Answer:
kilogram
In the International System of Units (SI), the kilogram is the basic unit of mass, and the newton is the basic unit of force. The non-SI kilogram-force is also a unit of force typically used in the measure of weight.
Fairly easy question I’ll give extra points help.
Answers
1. third law
2. first law
3. third law
4. second law
The moment of inertia of the club head is a design consideration for a driver in golf. A larger moment of inertia about the vertical axis parallel to the club face provides more resistance to twisting of the club face for off-center hits. The mass of one club head is 200 g and its moment of inertia is 5000 g cm2 . What is the radius of gyration of this club head
Answers
Answer:
Explanation:
Moment of inertia I = M k² , where M is mass and k is radius of gyration .
Putting the given values in the equation
5000 = 200 x k²
k² = 25
k = 5 cm .
Radius of gyration is 5 cm .
The low pressure area near Earth's equator is filled by cool air moving in from
А
Europe and South America
B
the North and South Pole
с
the Prime Meridian
D
the Atlantic and Pacific Ocean
Answers
When a 20 kg explosive detonates and sends a 5 kilogram piece traveling to the right at 105 m/s
what is the speed and direction of the other 15 kilogram piece of the explosive!
Answers
Answer:
speed: 35m/s
direction: left
Explanation:
Assuming the right side is the positive direction:
before explosion:
P = mv = 0
after explosion:
P' = 15P + 5P
(Set the velocity of the 15kg piece after explosion as v1' and the velocity of the 5kg piece after explosion as v2')
P' = 0.75mv1' + 0.25mv2'
P' = (15kg)v' + (5kg)(105m/s)
P' = 525kg/m/s + (15kg)v1'
P = P'
525kg/m/s + (15kg)v1' = 0
(15kg)v1' = -525kg/m/s
v1' = -35m/s
speed = |-35| = 35m/s
direction is to the left since the right side is the positive direction.
Calculate the terminal velocity of
the following nain drops faning
through air (a) one with a diameter
of 0.3cm 6 one with a a diameter
of o. Olm. Take the density of
water to be looo Kym3 and the
eis cosity of air to be ixlos pas.
The buoyancy effect of the air
may be ignored)
Answers
Convert (a) 50 oF, (b) 80 oF, (c) 95 oF to Celsius
Answers
The elastic energy stored in your tendons can contribute up to 35 % of your energy needs when running. Sports scientists have studied the change in length of the knee extensor tendon in sprinters and nonathletes. They find (on average) that the sprinters' tendons stretch 41 mm , while nonathletes' stretch only 33 mm .
Answers
Hello. Your question is incomplete. However, I managed to find it completely on the internet and I realized that you forgot to mention that the question asks you for the maximum energy difference between velovistas and non-athletes, considering that the spring constant for the tendon of the two groups is equal to 33n/mm.
To make this calculation you will need to use Hooke's law, using the formula: ¹/2*K*x², where "K" will be the value of the spring constant for the tendon and "X" will be the value of the sprinter and non-athlete terms.
So for the sprinter we will have the calculation:
¹/2*33*41² -------> 0,5*33*1681 = 27736. 5 Nmm
(To facilitate the calculation, first solve the division of ¹/2 and then multiply 41 by 41, lastly, just multiply all the results.)
For the non-athlete we will have the calculation:
¹/2*33*33² -------> 0,5*33*1089 = 17968. 5 Nmm
(To facilitate the calculation, first solve the division of ¹/2 and then multiply 41 by 41, lastly, just multiply all the results.)
Now, to reach the final result, you only need to subtract the two values presented by the sprinter and the non-athlete.
27736.5 - 17968.5 = 9768 Nmm
Please help me with this review question.
Answers
Answer:
28.7%
Explanation:
efficiency = work output /work input × 100
Two students are sitting 1.50 m apart. One student has a mass of 70.0 kg and
the other has a mass of 52.0 kg. What is the gravitational force between them?
A. 8.01 x 10-9
B. 1.08 x 10-2
C. 2.28 x 10-8
Answers
Answer:
B
Explanation:
A baby carriage is sitting at the top of a hill that is 21 m high. The carriage with the baby weighs 20
kg. The carriage has
energy. Calculate it
Answers
Answer:
Energy in carriage (Potential energy) = 4,116 J
Explanation:
Given:
Mass of baby = 20 kg
Height = 21 m
Find:
Energy in carriage (Potential energy)
Computation:
The energy accumulated in an object as a result of its location relative to a neutral level is known as potential energy.
In carriage accumulated energy is potential energy.
Energy in carriage (Potential energy) = mgh
Energy in carriage (Potential energy) = (20)(9.8)(21)
Energy in carriage (Potential energy) = 4,116 J
4) Which statement about teamwork is not true?
A) Team members should not have to make personal sacrifices for the success of the team.
B) To be successful, all team members need to agree about how to achieve the goal.
C) To achieve agreement, teams must be able to communicate and negotiate.
D) Team members need to be ready to resolve conflicts in an open and honest way
Answers
Answer: A) Team should not have to make personal sacrifices for the success of the team.
Explanation:
HELP URGENT PLEASE!!!!!!!
Answers
Answer:
I think c I dont know sorry if I'm wrong
Which device converts electric energy into mechanical energy?
O A. An electromagnet
O B. A motor
O C. A transformer
O D. A generator
Answers
Answer:
B motor
Explanation:
A bullet of mass 4.00 g is fired horizontally into a wooden block of mass 1.30 kg resting on a horizontal surface. The coefficient of kinetic friction between block and surface is 0.170. The bullet remains embedded in the block, which is observed to slide a distance 0.240 m along the surface before stopping. Part A What was the initial speed of the bullet
Answers
Answer:
[tex]291.67\ \text{m/s}[/tex]
Explanation:
[tex]m_1[/tex] = Mass of bullet = 4 g
[tex]m_2[/tex] = Mass of block = 1.3 kg
[tex]\mu[/tex] = Coefficient of friction = 0.17
[tex]s[/tex] = Displacement of block = 0.24 m
[tex]v_1[/tex] = Velocity of bullet
[tex]v[/tex] = Velocity of combined mass
[tex]g[/tex] = Acceleration due to gravity = [tex]9.81\ \text{m/s}^2[/tex]
The energy balance of the system is given by
[tex]\dfrac{1}{2}(m_1+m_2)v^2=\mu(m_1+m_2)gs\\\Rightarrow v=\sqrt{2\mu gs}[/tex]
As the momentum is conserved in the system we have
[tex]m_1v_1=(m_1+m_2)v\\\Rightarrow m_1v_1=(m_1+m_2)\sqrt{2\mu gs}\\\Rightarrow v_1=\dfrac{(m_1+m_2)\sqrt{2\mu gs}}{m_1}\\\Rightarrow v_1=\dfrac{(4\times 10^{-3}+1.3)\times \sqrt{2\times 0.17\times 9.81\times 0.24}}{4\times 10^{-3}}\\\Rightarrow v_1=291.67\ \text{m/s}[/tex]
The initial speed of the bullet is [tex]291.67\ \text{m/s}[/tex].
Can someone tell me anything useful about energy management in the human body?
Answers
Answer:
The human body carries out its main functions by consuming food and turning it into usable energy. Immediate energy is supplied to the body in the form of adenosine triphosphate (ATP). Since ATP is the primary source of energy for every body function, other stored
Explanation:
this what teacher explain to us
Basic Science!! Helppp
Answers
as input is chemical (fuel) and heat(thermal) is wasted
Why is it harder to breathe on a
mountain?
A. The air pressure is so high the lungs can't expand.
B. The air is denser and oxygen can't flow easily into the
lungs.
C. The denser oxygen molecules sink below the
surrounding air.
D. The air is less dense so there are fewer oxygen
molecules.
Answers
2. Plastic is a great conductor of charge so it moves quicker.
True
False
Answers
Answer:
the answer is false
Explanation:
plastic doesnt conduct anything
What is the term used to describe the
force pushing on an area or surface?
A. density
B. pressure
C. surface tension
D. volume
Answers
Explanation: The force pushing on a surface divided by the area of that surface is called pressure