Name two elements that have the same properties as sodium (Na)

Answer: photosphere.

Explanation:

The part of the Sun commonly called its surface is the photosphere. The word photosphere means "light sphere" – which is apt because this is the layer that emits the most visible light. It’s what we see from Earth with our eyes.

Answer:

4) 1.5 mol

Explanation:

Well, the equation is already balanced and the mole to mole ratio of reactants and products are all 1. So if the limiting reactant is HCl and you have 1.5 mol, you do the mole to mole ratio with NaCl and since it is 1 to 1, there'd be 1.5 mol of NaCl.

The equilibrium constant of the reaction is 0.042.

The reaction equation is given as;

PCl5(g) ⇄ PCl3(g) + Cl2 (g)

Recall that this equation shows the decomposition of phosphorus pentachloride.

We have the following equilibrium concentrations;

[PCI5]= 0.0095 M

[PCI3] = 0.020

[CI2] = 0.020 M

The equilibrium constant, K is obtained from;

K =  [PCI3]  [CI2]/[PCI5]

K = [0.020]^2/[0.0095]

K = 0.042

Learn more: https://brainly.com/question/17960050

Answer: Metals conduct heat and reduce the kinetic energy within the components that need to remain cool.

Explanation:

Answer:

Magnesium is Mg.

Phosphorus is P.

Answer:

Explanation:

Endo and Exo thermic are defined by what changes take place in the environment of the reaction.

If the temperature goes up, the reaction is giving up heat. It is Exothermic.

If the temperature goes down, the reaction requires heat. It is Endothermic.

In this case, the temperature went down. The reaction is Endothermic.

Answer:

Part 1: Condensation is when - a

Condensation happens when- water vapour suddenly freezes

Part 2: Water, condenses, vapour, cold, droplets, Condensation

find the distance between

the following points:

a) AC0₂0) and B(5, 2)

Answer: Global warming causes sea-level rise as oceans expand, and makes storm patterns more energetic. Consequently it will affect most of the world's coastlines through inundation and increased erosion.

Explanation:

Answer:

D.

Explanation:

A concentrated solution is one that has a lot of solute (the substance being dissolved) in the solvent (the substance doing the dissolving). When a solution is concentrated, it means it has a high ratio of solute to solvent, so the answer is D.

Hope this helps.

The mass of water needed to absorb 456 J is 1.44 g

We'll begin by calculating the change in the temperature of the water.

Initial temperature of water (T₁) = 22.7 °C

Final temperature (T₂) = 98.3 °C

ΔT = T₂ – T₁

ΔT = 98.3 – 22.7

Heat absorbed (Q) = 456 J

Change in temperature (ΔT) = 75.6 °C

Specific heat capacity of water (C) = 4.184 J/gºC

Q = MCΔT

456 = M × 4.184 × 75.6

456 = M × 316.3104

Divide both side by 316.3104

M = 456 / 316.3104

Therefore, the mass of the water is 1.44 g

Learn more: https://brainly.com/question/15563205

Answer:

The strongest intermolecular force in sulfur dioxide is dipole-dipole forces.

Explanation:

The interparticle force in [tex]SO_{2}[/tex] (sulfur dioxide) is the dipole-dipole interaction.

Dipole-dipole interaction is a type of intermolecular force that occurs between polar molecules. Polar molecules have a permanent dipole moment, which means they have a partial positive charge on one end and a partial negative charge on the other end. This creates an electrostatic attraction between the partial charges of neighboring molecules. The stronger the dipole moment of a molecule, the stronger its dipole-dipole interaction will be with other polar molecules.

Dipole-dipole interactions are responsible for a variety of physical properties of substances, including their boiling and melting points. Substances with strong dipole-dipole interactions tend to have higher boiling and melting points than substances with weaker interactions. In addition, the strength of dipole-dipole interactions can affect solubility, as polar substances tend to dissolve better in other polar substances due to their ability to form dipole-dipole interactions.

Learn more about dipole-dipole interaction, here:

https://brainly.com/question/30510859

#SPJ2

Answer:

2:true

3: true

4:false

5: true

Explanation:

Answer:

Both

Explanation:

if you pull a mountain a part that would be great consequences and if a volcano breaks there will be fire .

Answer:

By their properties ;)

Explanation:

[tex]\Large \boxed{\sf by \ their \ properties}[/tex]

Every element has a set of particular characteristics. Each has a unique atomic and mass number because they contain a different ratio of protons and neutrons. The number of protons in an element mirrors the element's atomic number. The mass number equals the sum of the element's protons and neutrons.

According to increasing atomic numbers, chemical elements get organized. Periods and groups are the names of the horizontal rows and vertical columns, respectively. The chemical characteristics of elements within the same group are comparable due to their similar valency and number of outer electrons.

This question is providing the masses of carbon dioxide and oxygen gases at 10.0 atm as 66 g and 16 g respectively, and is asking for the partial pressure of the former which turns out to be 7.50 atm after doing the math.

Thus, we can start solving this problem with the Dalton's law approach, in order to make a relationship for the total pressure, partial pressure and mole fraction, which means we must first determine the mole fraction of carbon dioxide gas in the mixture as shown below:

[tex]x_{CO_2}=\frac{n_{CO_2}}{n_{CO_2}+n_{O_2}}[/tex]

Next, we calculate the moles of both gases by dividing the grams over the molar masses:

[tex]n_{CO_2}=\frac{66g}{44.01g/mol} =1.50mol\\\\n_{O_2}=\frac{16g}{32g/mol} =0.5mol[/tex]

Then, the mole fraction of carbon dioxide as the required one by plugging in the previously calculated moles:

[tex]x_{CO_2}=\frac{1.5}{1.5+0.5}=0.75[/tex]

Finally, we use the definition of the Dalton's law to calculate the partial pressure of carbon dioxide gas in the binary mixture:

[tex]P_{CO_2}=x_{CO_2}P\\\\P_{CO_2}=0.75*10.0atm\\\\P_{CO_2}=7.50 atm[/tex]

Learn more:

(Dalton's law) https://brainly.com/question/14119417

Answer:

Volume occupied is approx.  

38 ⋅ ML

Explanation:

Density  ρ = Mass  Volume  And thus  Volume  = Mass  ρ = 1.592 ⋅ l b × 454 ⋅ g ⋅ l b − 1 19.3 ⋅ g ⋅ m L − 1   =   ? ? ⋅ m L

Answer:

    2H2    +   1 O2   ------>    2H2O

m = 12.7g                              m = ?

Get the number of moles for Hydrogen gas (H2) by dividing the mass by the molar mass (1.01g/mol as listed in the periodic table for its atomic mass)

12.7/1.01 = 12.57 mol of H2

Now use the mole to mole ratio of Hydrogen gas (H2) and water (H2O).

From the balanced equation, we can see that 2 mol of H2 gives us 2 mol of H2O. Since both of the ratios are equal (2:2), the moles we have for hydrogen gas is the same as the moles we get for water.

12.57 mol of H2O

Now that we have the amount of mol for H2O produced in this reaction, we can convert it to grams by multiplying the moles by the molar mass.

Molar mass of H2O = (1.01 x 2) + (16) = 18.02g/mol

12.57 x 18.02 = 226.5g (rounded)

Therefore 226.5g of water will be produced in this reaction

According to law of conservation of mass and stoichiometry, 114.3 g of water are produced if 12.7 grams of hydrogen reacted with an unknown amount of oxygen.

According to law of conservation of mass, it is evident that mass is neither created nor destroyed rather it is restored at the end of a chemical reaction .

Law of conservation of mass and energy are related as mass and energy are directly proportional which is indicated by the equation E=mc².Concept of conservation of mass is widely used in field of chemistry, fluid dynamics.

2 H₂ + O₂[tex]\rightarrow[/tex] 2 H₂O,according to this equation,4 g hydrogen reacts with 32 g oxygen to give 36 g water, thus 12.7 g of hydrogen will produce 12.7×36/4=114.3 g water and hence for this amount of water to be formed  12.7 g of hydrogen reacts with 101.6 g of oxygen which is obtained as 114.3-12.7=101.6 g

Thus, 114.3 g of water is produced.

Learn more about law of conservation of mass,here:

https://brainly.com/question/28711001

#SPJ2

Answer:

FIGURE 5.9 The arrow shows a second way of remembering the order in which sublevels fill. Table 5.2 shows the electron configurations of the elements with atomic numbers 1 through 18.

Element Atomic number Electron configuration

sulfur 16 1s22s22p63s23p4

chlorine 17 1s22s22p63s23p5

argon 18 1s22s22p63s23p6

Explanation:

Brainlilest me

Answer:

Artificial selection, also called "selective breeding” is where humans select for desirable traits in agricultural products or animals, rather than leaving the species.

Answer:

a subshell is a subdivision of electron shells that are separated by electron orbitals.

Explanation:

(subshells are labeled s,p,d, and f in an electron configuration)

Answer:

Definition and Mathematics of Work

Calculating the Amount of Work Done by Forces

Potential Energy

Kinetic Energy

Mechanical Energy

Answer:

the force that you applied caused the notebook to move.the force applied on the notebook by the table causes it to stop moving. this is because after sometime the book uses up the force and later the force you applied is less than that of the force by the table.

Answer:

3 elements are present in thr compound

Answer:

I think the answer is A physical property is a characteristic of a substance that can be observed or measured without changing the identity of the substance. Physical properties include color, density, hardness, and melting and boiling points. A chemical property describes the ability of a substance to undergo a specific chemical change.

Explanation:

I hope this helps.

Answer:

Physical change is the same substance, while a chemical change is a new substance.