oxygen is odorless and colorless physical or chemical

Answer:

Higher pitched sounds produce waves which are closer together than for lower pitched sounds. (Think of the slinky - if you produce waves rapidly they will travel quite close to each other, thus demonstrating a higher pitched sound.)

The pitch of a note will depend on a number of factors. One of these is the size of the vibrating object. On a glockenspiel or xylophone the high notes are made by the smaller bars. A smaller triangle or cymbal will make a relatively higher pitch note. On a stringed instrument such as a guitar or violin a thinner string will generally make a higher note, but also shortening the string by stopping it with the finger will produce a similar effect. On a set of pan pipes or a church organ it is the shorter pipes which make the higher notes when the air inside them vibrates.

Another factor which produces higher pitched notes is the tension within the vibrating object. A guitar string can be tuned to a higher pitch by adjusting the string tensioner. An elastic band can be stretched tighter and a drum skin can be tensioned to increase the pitch of the sound it produces.

The elements fluorine (F), chlorine (CL),and Iodine are all parts of the same _group___ on the periodic table

Answer:

Would you consider adding a sodium carbonate solution to a magnesium sulfate .

Explanation:

??

Answer: is equal to the gravitational pull on an object

Explanation:

Explanation:

When a bond is strong, there is a higher bond energy because it takes more energy to break a strong bond. This correlates with bond order and bond length. When the bond order is higher, bond length is shorter, and the shorter the bond length the greater the bond energy.

Answer:

droplets of sulfuric acid

Explanation:

Answer:

Dry ice is the solid form of carbon dioxide (CO 2), a molecule consisting of a single carbon atom bonded to two oxygen atoms. Dry ice is colorless, odorless, and non-flammable, and can lower the pH of a solution when dissolved in water, forming carbonic acid (H 2 CO 3).

Explanation: i asked my teacher and this was her response.

Taking into account the definition of calorimetry, the mass of the sample is 478.41 grams.

Calorimetry is the measurement and calculation of the amounts of heat exchanged by a body or a system.

Sensible heat is defined as the amount of heat that a body absorbs or releases without any changes in its physical state (phase change).

So, the equation that allows to calculate heat exchanges is:

Q = c× m× ΔT

where Q is the heat exchanged by a body of mass m, made up of a specific heat substance c and where ΔT is the temperature variation.

In this case, you know:

Replacing:

-543 J= 0.227 [tex]\frac{J}{gC}[/tex]× m× (-5 C)

Solving:

[tex]m=\frac{-543 J}{0.227 \frac{J}{gC}x(-5 C)}[/tex]

m=478.41 grams

In summary, the mass of the sample is 478.41 grams.

Learn more about calorimetry:

Lithium oxide is able to undergo both the processes of dissolution and dissociation.

Dissociation refers to the break down a chemical substance into its constituents. Ionization refers to the loss of electrons from a chemical specie while dissolving refers to the ability of a solid to form a solution.

Let us now look at each of the following species;

Learn more about ionization: https://brainly.com/question/1602374

Answer:

C6H12O6

Explanation:

First you need to find the empirical formula by the percents that they're giving you. You assume that is 100 grams and if for example you have 40% of carbon you will have 40 grams of carbon.

1.Find the number of moles of each atom

C: 40g÷12g/mol= 3.33 mol

H: 6.7g÷1g/mol= 6.7 mol

O: 53.3g÷16g/mol= 3.33 mol

You divide all ratios by the minimum ratio and you obtain the empirical formula

CH2O

Since you're given the molar mass, you now have to find the molar mass of CH2O by adding the molar mass of each element present and repeated in the compound.

CH2O= 30g/mol

Now you know that the molar mass of the molecular formula we are looking for is 180.18 g/mol, and since the empirical formula is the molecular formula in its smaller ratio, by logic you can say that:

180.18g/mol ÷ 30g/mol= 6

So, you now know that the empirical formula is being multiplied by a factor of 6 to reach a compound with a molar mass of 180.18g/mol, so you multiply each subscript of the empirical formula by 6 obtaining:

C6H12O6

Answer:

Because they are electrical conductors because their delocalized electrons carry electrical charge through the metal. they are good conductors of thermal energy because their delocalized electrons transfer energy.

I hope it helps.

i have no idea what you said but for the sake of god its true

Answer:

1031.084g

Explanation:

n=m/M

m=n(M)

m = (3.4mol)(303.26g/mol)

1031.084g

Hope that helps

Answer:

1031.08

Explanation:

You start with 3.4 moles and you know that 6.022 x 10 ^ 23 = 1 mole( Avogadro's Number), so you just multiply those 2 numbers and the moles will cancel leaving you with grams of Lead Sulfate.

Answer:

cell

Explanation:

Cells are the most simple, basic units of life

Answer:

the CELL is the basic unit of life.

Explanation:

I had this is my science lesson

have a great day!

hope this helps!

feel free to mark as brainliest! ;)

The compound that contains both sigma and pi bonds has been [tex]\rm \bold{H_2CO}[/tex]. Thus, option B is correct.

The compounds have been resulted by the sharing of the valence electrons between atoms, for the completion of octet of each elements.

The bonds can be saturated with the presence of only sigma bond. The unsaturated bonds has presence of pi bonds as well. The bond with one pi and one sigma has been a double bond, while 1 sigma and 2 pi has been a triple bond.

The bonds present in the following structures has been:

[tex]\rm HCCl_3=4\;\sigma\;bonds\\H_2CO=2\;\sigma,\;1\;\pi\;bond\\H_2S=2\;\sigma\;bonds\\HBr\;=1\;\sigma\;bond[/tex]

The compound with the presence of both sigma and pi bonds has been [tex]\rm \bold{H_2CO}[/tex]. Thus, option B is correct.

For more information about the sigma and pi bonds, refer to the link:

https://brainly.com/question/14018074

Answer:

Blank #1: Polyatomic

Blank #2: 2 (see explanation)

Blank #3: 1 (see explanation)

Explanation

Both the ammonium ion  and the sulfate ion  contain more than one atom in each ion. The two species are thus polyatomic. The chloride ion , for example, is monoatomic.

Superscripts above formulae of the ions indicate their charge. Each ammonium ion carries a positive one (+1) charge. Each sulfate ion carries a charge of negative two (-2).

Ammonium sulfate is an ionic compound. A sample of this compound contain myriads of ammonium ions and sulfate ions. The ions are packed in three-dimensional lattices. Thus unlike water, ammonium sulfate does not exist as molecules in nature.

Assuming that the second and third blanks refers to a formula unit, rather than a molecule, of ammonium sulfate. The empirical formula of ammonium sulfate gives the minimum whole-number ratio between the two ions in a sample.

Charges shall balance between the two ions. Ammonium ions are of charge +1. Sulfate ions are of charge -2. The sample shall thus contain two ammonium ions for every one sulfate ion.

The empirical formula of ammonium sulfate is therefore .

There are thus two ammonium ions  and one sulfate ion  in each formula unit of ammonium sulfate.

There are two types of chemical compound one is covalent compound and other is ionic compound, covalent compound formed by sharing of electron and ionic compound formed by complete transfer of electron. Therefore,  a molecule of the ammonium sulfate consists of one NH₄⁺ ions and one SO₄²⁻ ions.

Chemical Compound is a combination of molecule, Molecule forms by combination of element and element forms by combination of atoms in fixed proportion.

An ionic compound is a metal and nonmetal combined compound.  Ionic compound are very hard. They have high melting and boiling point because of strong ion bond. The compound of ammonium sulfate consists of two ions. NH₄⁺ and SO₄²⁻ both of which are polyatomic ions. A molecule of the ammonium sulfate consists of one NH₄⁺  ions and one SO₄²⁻ ions.

Therefore,  a molecule of the ammonium sulfate consists of one  NH₄⁺ ions and one SO₄²⁻ ions.

To learn more about chemical compound, here:

brainly.com/question/26487468

#SPJ2

Answer:

Color change, formation of bubbles, and temperature change

Answer:

6.75g of hydrogen will completely react with 54g of oxygen

Explanation:

The neutral atom is isoelectronic with N⁻³ is Neon (Ne).

Isoelectronic are those which have same number of electrons or we can say that same electronic structure.

For finding out that the species are isoelectronic , we just have to count there no. of electrons of atoms and if they have same no. of electron then they said to be isoelectronic species.

no. of electrons in Nitrogen N = 7 ( atomic no.)

no. of electrons in Nitride ion N⁻³ = 7 + 3 = 10

no. of electrons in Neon Ne = 10 ( atomic no. and neutral atom)

so, no. of electrons in Nitride ion N⁻³  = no. of electron in Neon Ne

this means , N⁻³ , Nitride ion is isoelectronic with Neon Ne.

Thus, The neutral atom is isoelectronic with N⁻³ is Neon (Ne).

To learn more about isoelectronic species here

https://brainly.com/question/16899641

#SPJ1

Answer:

The temperature stays the same and the particle speed stays constant

Answer:

Melting point, boiling point, state of matter at room temperature, heat of vaporization, flammability and reactivity

Explanation:

Answer:

A single covalent bond

Explanation:

A single covalent bond is when only one pair of electrons is shared between atoms. A sigma bond is the strongest type of covalent bond, in which the atomic orbitals directly overlap between the nuclei of two atoms.

Answer:

Single covalent bond.

Explanation:

Single covalent bond is the type of bond in which only one pair of electrons is shared between atoms.

[tex]\rule[225]{225}{2}[/tex]

Hope this helped!

Answer: All options (I, II, III, IV, V)

Explanation: The answer is all options because they never reach equilibrium or intersect at a region as the both decrease at the same rate.

Answer: Picture shows the correct one

Explanation:

Answer:

Hi this is Adhira please make me as brainlist

Explanation:

The nutritional status indicators for the CDC Growth Charts include obesity, overweight, underweight, and short stature. Percentiles are used to rank an individual or a group on a growth chart and indicate where either fits in the context of the reference population

The IUPAC name for a binary covalent compound will lack roman numerals.

Binary covalent compound comprises of two elements which forms a

compound through the sharing of electrons.

The sharing of electrons is referred to as covalent bonding and naming such

compounds require prefixes such as mono-, di- , tri- etc.

The standard method of naming these compounds should be with the

prefixes and not with the roman numerals.

An example is carbon(IV)oxide which is wrong in  IUPAC naming.

Read more on https://brainly.com/question/16731560

Answer:

B

Explanation:

Just did the test on edge 2021

Answer:

The ground state represents the lowest-energy state of the atom.

Explanation:

sd