Part B
At your sink, turn on your faucet slowly, until you have achieved a steady drip, drip, drip of lukewarm water. Make sure you can visually see and count the drips. Align the center of the bar of soap with the dripping water and set it down. Make sure the soap is in a sturdy location and does not move during the experiment. The soap represents a rock, and the dripping faucet represents precipitation.

While the soap is being weathered, calculate the number of drips that hit it in a minute. Do this by using your stopwatch to count the number of drips that occur in 10 seconds, and then multiply that number by 6 (because there are 60 seconds in a minute, 6 × 10 = 60). What is the number of drips hitting your bar of soap per minute?

Answer:

if you doctor suspect that you have COPD , they will calculate your fev1/fvc ratio . this represent the percentage of your lung capacity that you can explain in one second. the higher your percentage , the larger your lung capacity and the healthier your lungs

The ratio  [tex]\frac{FEV1}{FVC}[/tex]  indicates the diameter of an airway. The greater the value, the more quickly air can pass through the airway.

The volume of air in the lungs at different stages of the respiratory cycle is referred to as lung volumes and lung capacities. An adult human male's entire lung capacity is around 6 liters of air.

The ratio  [tex]\frac{FEV1}{FVC}[/tex]  indicates the diameter of an airway. The greater the value, the more quickly air can pass through the airway. As a result, the lower the resistance, the broader the airway becomes.

Hence the lower the resistance, the broader the airway becomes.

To learn more about the lung volume refer to the link;

https://brainly.com/question/15704673

#SPJ4

Answer:

Uranus

Explanation:

Your welcome

A planet is a celestial body. The third-largest planet in the solar system is Uranus.

A celestial body is differentiated from the fixed stars by its apparent mobility (including the moon and sun), especially in relation to its claimed impact on people and events.

A planet is a celestial body. The third-largest planet in the solar system is Uranus.

Learn more about Planet:

https://brainly.com/question/14581221

#SPJ4

Answer: A Nebula is left behind. A spectacular explosion in which a star ejects most of its mass in a violently expanding cloud of debris.

Hope this helps!

Polarization refers to the tendency for acquiring specific orientation by the oscillation.

Polarization is a property that specifies the geometrical orientation of the oscillations. In a transverse wave, the direction of the oscillation is perpendicular as compared to other that have parallel.

So we can conclude that Polarization refers to the tendency for acquiring specific orientation by the oscillation.

Learn more about polarization here: https://brainly.com/question/3040056

Answer:

B. Energy

Explanation:

Sound is a kind of energy. In physics, sound is seen as anenergy that is generated through vibrations

Answer:

Energy

Explanation:

Answer:

Vaccum

Explanation:

You can test it .

Answer:

No, the eggs are in direct contact with the metal pan, which is in direct contact with the gas flame, so this is conduction, not radiation

Reasons:
-Thermal energy is being transferred by conduction.

-Radiation transfers thermal energy by electromagnetic waves.

-Radiation does not transfer thermal energy by direct contact.

Radiation heat transfer is a process where heatwaves are emitted that may be absorbed, reflected, or transmitted through a colder "body". Sun heats the earth by electromagnetic waves. The sun does not come in physical contact with the Earth to transfer heat. (In my opinion, the Earth touching the sun would not be on my to-do list.)

Explanation:

Have a great rest of your day
#TheWizzer

Answer:

the current of 12 ohm is 2Amps

Answer: When you name an element, it's usually because the element is newly discovered. So by naming an element you are creating something that will last throughout history.

Explanation:

Answer:

Edmond Locard

Explanation:

Hope this helps :)

The three types of equilibrium in an object are;  stable, unstable, or neutral equilibrium.

The term equilibrium refers to a situation in which all the forces acting on an object are balanced such that the object does not move. The question is incomplete as the images are missing.

There are three types of equilibrium:

Learn more equilibrium of forces: https://brainly.com/question/12262457

When an object standing on the floor is tipped, the height of its center of gravity (cg) for each case as stable, unstable, or neutral may increase, decreased and remain same respectively.

Equilibrium is the location of the body, in which the body be static or in motion and does not change it with respect to time.

The equilibrium of an object can be classified in the 3 following types.

When an object standing on the floor is tipped, the height of its center of gravity (cg) may or may not change.

The stability of object demands in the center of gravity. Lower the value of CG, results in more stable object. For each case,

Thus, when an object standing on the floor is tipped, the height of its center of gravity (cg) for each case as stable, unstable, or neutral may increase, decreased and remain same respectively.

Learn more about the equilibrium state here;

https://brainly.com/question/1233365

#SPJ4

Answer: .0380575J

Explanation:

The coffee filter originally only had potential energy, which can be found by:

PE = m * g * h → PE = .0013 * 9.8 * 3 = .03822 J

*Note the mass must be in kg!!!

All of this energy should be converted to kinetic energy, but the air molecules take some of the energy; the energy they gain can be found by finding how much energy the filter has at the bottom of its fall, and subtracting this from the original energy to see how much was lost;

All of the energy at the bottom equals kinetic energy, which can be found by:

KE = 1/2 * m * v^2 → KE = 1/2 * .0013 * .5^2 = .0001625 J

Thus, the air gained .03822 - .0001625 = .0380575J :)

Answer:

300newtons of centripetal force

Explanation:

Force is mathematically expressed as mass×acceleration due to gravity

Mass of child equals 30kg

Acceleration due to gravity equals 10m/s²

Force is unknown so we restate formula & fix in the quantities

∴Force equals mass×acceleration due to gravity

(representing force by f,mass by m & acceleration...gravity by g)not always necessary

So f equals m×g(fix in values)

f equals 30kg×10m/s²

f equals 300newtons

∴The centripetal force acting on her is 300newtons

Answer:

200 N Right

Explanation:

The 50 up and 50 down  balance or 'cancel' each other

   then you only have the 200 N to the right

This is defined as a propagation of disturbances from place to place in a regular and organized way.

The answers provided above are therefore the most appropriate choices in this scenario.

Read more about Waves here https://brainly.com/question/15663649

Answer: Light waves do not require a medium to propagate and As a wave's frequency increases, more energy is carried by the wave in a given time period.

Explanation:

The total resistance and current flowing through the circuit is equal to 60 Ohms and 2 Amperes respectively.

Given the following data:

Resistors = 20 Ohms.

Voltage = 120 Volts.

Since the three resistors are connected in series, we would calculate their total resistance by adding them up as follows:

RT = R1 + R2 + R3

RT = 20 + 20 + 20

RT = 60 Ohms.

Next, we would determine the current that is flowing through the circuit by applying Ohm's law.

From Ohm's law, we have:

V = IR

I = V/R

I = 120/60

I = 2 Amperes.

Read more resistance here: https://brainly.com/question/25813707

Answer:

avg w= (delta theta)/delta T = (10 rad/s - 8 rad/s) / (4 s-0) = .5 rad/s Vt= r * avg w = 4m * .5 rad/s = 2 rad/s

A light-year is a unit of measurement which is used to measure distance between the Earth and the sun.

This is defined as the distance light travels in the time it takes the Earth to orbit the Sun.

It is also the distance a beam of light travels in a single earth year which is why option C was chosen as the most appropriate choice.

Read more about Light year here https://brainly.com/question/76984

Explanation:

Gravity = 1.6 m/s^2

Mass = 85 kg

Full infomation needed your question is incomplete and BTW fomula : G Mm

R^2

Answer: When a car is struck by lightning, the resulting electric field inside the car is zero.

Explanation:

Answer:

2.5A

Explanation:

We know the relation :

V = IR

By using the formula,

Answer :-

Explanation :-

As per the provided information in the given question, we have been given that the Potential Difference is 30 Volt . The Resistance is given as 12 Ohm . And, we have been asked to calculate the Current of the Device.

For calculating the Current , we will use the Formula :-

[tex] \bigstar \: \: \: \boxed { \sf{ \: Current \: = \: \dfrac{Potential \: Difference}{Resistance} \: }} [/tex]

Therefore , by Substituting the given values in the above Formula :-

[tex] \dag \: \: \: \sf { Current \: = \: \dfrac{Potential \: Difference}{Resistance} } [/tex]

[tex] \longmapsto \: \: \: \sf { Current \: = \: \dfrac{30}{12} } [/tex]

[tex] \longmapsto \: \: \: \textbf {\textsf {Current \: = \: 2.5 }} [/tex]

Hence :-

[tex]\underline {\rule {180pt} {4pt}} [/tex]

Answer:

The moons gravity is 1.62 m/s²

Answer:

A protostar is the earliest stage of a star's life. A star is born when the gas and dust from a nebula become so hot that nuclear fusion starts.

The origin of star is called nebula. The earliest stage of a star’s life before it begins to undergo fusion is known as a protostar.

Every star begins from nebula. A nebula is a huge gas and dust cloud. Some of the gas and dust in a nebula can be drawn together by gravity. The cloud's contraction is then described as a protostar. The first stage of a star's life is called a protostar.

As the gas and dust from a nebula heat up to a point where nuclear fusion begins, a star is created. A star is referred to as a main sequence star once it has "switched on". A main sequence star turns into a red giant or a red super giant when its hydrogen fuel runs exhausted.

An exploding red super massive star is possible. It is referred to be a supernova. After the star explodes, some of the ingredients from the star are left behind. Hence, the earlier stage of a star before fusion starts is called a protostar.

Find more on protostar:

https://brainly.com/question/14317247

#SPJ2

Answer:

no sabo por q no mi entender

Answer:

Your answer would be:
B.) Both carry energy in the form of vibration

Explanation:

Have a great rest of your day
#TheWizzer

In nuclear reactors, control rods are used because reactions that occur in a nuclear reactor are highly exothermic in nature.

A nuclear reactor is an apparatus or structure in which  radioactive material can be made to undergo a commanded, self-sufficient nuclear reaction with the resultant release of energy.

Therefore, when these control rods are infused in a nuclear reactor, than it absorbs the neutrons and helps to control the chain reaction. As a result, the rate of chain reaction gets in control.

Thus, we can conclude that the statement control rods are used to slow down the reaction in the reactor core when the core becomes too hot is a true statement.

Thus In nuclear reactors, control rods are used because reactions that occur in a nuclear reactor are highly exothermic in nature.

To know more about Nuclear reactor follow

https://brainly.com/question/24295936

Answer:

TRUE ( T )

Explanation:

Just took the test on edge

Here is the solution for previous question

[tex]\\ \rm\rightarrowtail T=2\pi\sqrt{\dfrac{m}{k}}[/tex]

[tex]\\ \rm\rightarrowtail T\propto \sqrt{m}[/tex]

Hence

[tex]\\ \rm\rightarrowtail \dfrac{T_1}{T_2}=\sqrt{\dfrac{m1}{m2}}[/tex]

[tex]\\ \rm\rightarrowtail \dfrac{1.5}{2}=\sqrt{\dfrac{0.5}{m2}}[/tex]

[tex]\\ \rm\rightarrowtail 0.75^2=\dfrac{0.5}{m2}[/tex]

[tex]\\ \rm\rightarrowtail m_2=\dfrac{0.5}{0.75^2}[/tex]

[tex]\\ \rm\rightarrowtail m_2=0.888888888\dots[/tex]

So

from this

So it's infinite in terms of 8 so must be greter than one 8

We rounded it up for 3 decimals

So

Error range=[1.99,2.01]

Very mere one

Now find percentage

[tex]\\ \rm\rightarrowtail \dfrac{0.02}{2}(100)=0.01(100)=1\%[/tex]

Mass should be lied in

But for increase mass

it would be