please help me!! DUE TOMORROW :(

The most reasonable step to take will be to check the calibration of the

thermometer to ensure that it is giving accurate readings.

Experiments which are done to be give the same results under standard

conditions. Common causes of incorrect results during the analysis of

boiling point of substances include heating the substance too rapidly or

the thermometer not being properly calibrated.

The thermometer is used to measure the temperature and so must be

properly calibrated to give accurate readings.

Read more on https://brainly.com/question/24657998

The molarity of the NaOH solution required for the reaction is 0.186 M

We'll begin by writing the balanced equation for the reaction

H₂C₂O₄ +2NaOH —> Na₂C₂O₄ + 2H₂O

From the balanced equation above,

The mole ratio of the acid, H₂C₂O₄ (nA) = 1

The mole ratio of the base, NaOH (nB) = 2

From the question given above, the following data were obtained:

Volume of the acid, H₂C₂O₄ (Va) = 22.14 mL

Molarity of the acid, H₂C₂O₄ (Ma) = 0.105 M

Volume of the base, NaOH (Vb) = 25 mL

MaVa / MbVb = nA/nB

(0.105 × 22.14) / (Mb × 25) = 1/2

2.3247 / (Mb × 25) = 1/2

Cross multiply

Mb × 25 = 2.3247 × 2

Mb × 25 = 4.6494

Divide both side by 25

Mb = 4.6494 / 25

Therefore, the molarity of the base, NaOH solution is 0.186 M

Learn more: https://brainly.com/question/25739717

Answer:

Because it goes through the process of sublimation.

Explanation:

Answer:

Radioactive material

Explanation:

Answer:

Explanation:

Since the moles of gas and temperature are held constant the new volume can be found by using the formula for Boyle's law

[tex]V_2 = \frac{P_1V_1}{P_2} \\[/tex]

where

P1 is the initial pressure

P2 is the final pressure

V1 is the initial volume

V2 is the final volume

From the question

P1 = 1 atm

P2 = 2.25 atm

V1 = 250 mL

We have

[tex]V_2 = \frac{250 \times 1}{2.25} = \frac{250}{2.25} \\ = 111.1111111...[/tex]

We have the final answer as

Hope this helps you

Answer:: We're asked to find the molar concentration of the NaCl solution given some titration data.

Explanation:

Answer:

D

Explanation:

D is the correct answer due to the fact that they way they are connected has 2 purple atoms and 1 orange one. thus would create a 1:2 ratio with 1 orange atom and 2 purple atoms.

A would create a 2:3 ratio, B wouldn't create a ratio comparable to the others, and C creates a 1:1 ratio with a few purple atoms floating around them, making all of the answers except D invalid.

In the given figures, the name of the model representing a compound with a 1:2 is figure D.

Molar ration of any compound gives idea about the ratio of the concentration of given constituents present in that compound.

In the figure A molar ratio is 2:3, in figure B molar ratio of given constituents is not given because each molecule is composed of same types of atoms, in figure C molar ratio of given constitutes particles is 1:1 and in the figure D molar ratio of constituents is 1:2. Because in figure D, two atoms of one element and 1 atom of another element is present.

Hence, figure D is correct option.

To know more about molar ratio, visit the below link:
https://brainly.com/question/4408248

Answer:

Just as the Moon orbits the Earth because of the pull of Earth's gravity, the Earth orbits the Sun because of the pull of the Sun's gravity. ... This happens because the Earth has a velocity in the direction perpendicular to the force of the Sun's pull.

Explanation:

Answer:

First we know that the molar mass of CO2 is 44.01g/mol, and that the sample of CO2 contains 3.408 x 10^21 molecules, and we have to find the mass of that sample.

We know that moles = mass/molar mass, if we rearrange the equation for mass, we'll get:

mass = moles x molar mass

Also, note that the number of atoms/molecules in a sample is the moles of the sample x Avogadro's number (6.02 x 10^23)

If we rearrange the equation for moles, we would get:

moles = molecules of sample/6.02 x 10^23

Plug in the values for the equation above to get the moles:

moles = (3.408 x 10^21)/(6.02 x 10^23)

moles = 0.00566112956 (we're not done yet)

Now that we have the moles and we were already provided the molar mass, we can calculate the mass using the very first equation we rearranged.

mass = moles x molar mass

mass = 0.00566112956 x 44.01

mass = 0.2491g (answered 4 places past the decimal point)

Therefore the sample of Carbon Dioxide has a mass of 0.2491g

Answer:

3.5154 g/mL

Explanation:

You will need to use the equation Density = Mass/Volume. You are given mm(can be used to find volume) of a cube and kg(mass). Since your answer is in g and mL we should convert it to those sizes. First we want cm so we will divide the 127.58 mm to cm getting 12.758 cm. We want to cube it since we are finding the whole area of a cube( 12.758*12.758*12.758) which will equal 2076.58 cm^3. We know that 1 mL is equal to 1 cm^3, so we can take our 2076.58 cm^3 and label them as mL(which is what we want). Then we know that there are 1000g in 1 kg, so if we multiply the 7.3 kg, we get 7300g. Finally use the equation Density = Mass/Volume to get your answer. 7300g/2076.58mL = 3.5154 g/mL.

Hope this helps!

To balance a redox reaction, the increase and decrease in oxidation numbers must be balanced.

A redox reaction also called an oxidation- reduction reaction is a chemical reaction in which there is simultaneous gain and loss of electrons.

So, to balance a redox reaction, the simultaneous gain and loss of electrons must be balanced.

Thus, to balance a redox reaction, the increase and decrease in oxidation numbers must be balanced.

Learn more about redox reaction here:

https://brainly.com/question/15339159

Molecular substances tend to be gases because the intermolecular forces of attraction are comparatively weak. You don't have to break any covalent bonds in order to melt or boil a molecular substance.

The longest intermolecular separation and hence the strongest intermolecular pressure of attraction can be found in the gaseous state of matter.

Although solids' intermolecular interactions were sufficient to maintain themselves in locked places, gases often have weak intermolecular forces that cause them to remain considerably separated. The gases possess greater intermolecular space than solids as a result of these weak forces.

To know more about molecular forces:

https://brainly.com/question/21826959

#SPJ1

Answer:

When ionic compounds dissolve in water they go through a process called dissociation, splitting into the ions that make them up. However, when you place covalent compounds in water, they typically do not dissolve but form a layer on top of the water.

Answer:

Hexenes + Dioxygen = Carbon Dioxide + Water

The reaction type is combustion.

Its reactants are Hexenes - C6H12 and Dioxygen - O2

its products are Carbon Dioxide - CO2 and Water - H2O

Explanation: This was my yesterdays class

Answer:

It has a total of three elements and seven atoms. Another use that aluminum hydroxide has is it treats the symptoms of too much stomach acid. Some examples of what it treats are: upset stomach, heartburn, and acid indigestion.

Explanation:

Atomicity is the no of atoms present in one molecule. Atomicity of Al(OH)3 = 7.

The balance chemical equation and the type of reaction of AgNO₃ and the other compounds can be represented as follows;

2AgNO₃ + Cu → Cu(NO₃)₂ + 2Ag (single displacement )

2AgNO₃ → 2Ag + O₂ + 2NO₂ (decomposition reaction)

AgNO₃ + KCI → AgCI + KNO₃(double displacement reaction)

2Ag + I₂ → 2AgI (synthesis reaction)

AgNO₃ + Cu → Cu(NO₃)₂+ Ag

The balance equation is as follows:

This is a single displacement (substitution)  reaction. The Copper substance displaced silver from it compound.  

AgNO₃ → Ag + O₂ + NO₂

The balance equation is represented as follows:

The reaction is a decomposition reaction. Silver nitrate was decompose to it individual constituent.

AgNO₃ + KCI → AgCI + KNO₃

The balance equation is represented as follows:

The reaction is a double displacement reaction. The  anions and cations of two different compound switch places, forming two entirely different compounds.

Ag + I₂ → AgI

The balance equation is as follows:

The reaction is a synthesis reaction. The individual elements combined to form a compound.

learn more on chemical equation here:https://brainly.com/question/23453237?referrer=searchResults

Metal conductivity generally goes down or resistivity goes up with temperature goes up.

Answer:

1. How many moles of oxygen will occupy a volume of 2.5 liters at 1.2 atm and 25° C? PV = V (1.2 n. 0821) (298) = 123 mols 2.

2.0 moles of oxygen gas will occupy a volume of 6.67 L at the same temperature and pressure.

Moles is a unit of measurement used in chemistry to express the amount of a substance. It is a counting unit that represents the number of particles, such as atoms, molecules, or ions, in a given sample.

One mole of a substance is defined as the amount of that substance that contains Avogadro's number of particles, which is approximately 6.022 x 10²³. This number is based on the concept that atoms, molecules, and ions are extremely small and difficult to count individually, so using moles allows for a more practical and convenient representation of quantities.

Given:

Moles of oxygen gas (initial) = 0.45 mol

Volume of oxygen gas (initial) = 1.5 L

Moles of oxygen gas (final) = 2.0 mol

Volume of oxygen gas (final) = ?

Using the principle of molar volume, we can set up the following ratio:

(0.45 mol / 1.5 L) = (2.0 mol / V)

V = (1.5 L × 2.0 mol) / 0.45 mol

V = 6.67 L

Learn more about Moles, here:

https://brainly.com/question/26416088

#SPJ6

A molecule is essentially created by a collection of atoms linked by a network of bonds.

Answer:

clouds and precipitation that minimize temperature changes throughout the day

Explanation:

Answer:

curium

−

243

,

252

/

99

Es,  

251

/

98

Cf,  

214

/

82

Pb

Explanation: Im not very good with this but here ya go!

Answer: The growth of the plant decides on the presence of plant hormone, auxin which develops in the roots and shoots. Auxins change the rate of elongation in plant cells, controlling how long they become. So, if the tips are removed, there is no auxin made and growth of the plant stops.

Answer:

is easy to poiling

Explanation:

also is dificult to melting

Answer:

since the distance between the electron and the nucleus is smaller in B than in Li, the electrostatic nuclear force of attraction experienced by B is higher than the one experienced by Li...this translates to the higher first ionization energy in B than in Li.

Explanation:

i hope it's helping!