polar ? polar? polar? which is polar?

Answer:

[tex]2al + 3h2so4 = > al2(so4)3 + 3h2 \\ eqvt \\ = > \frac{5.4}{27} = > \frac{5 \times 50}{1000} \\ .2 \: mol = > .25 \: mol \\ \\ so \: .25 \: is \: limiting \: reagent \\ according \: to \: ideal \: gas \: equation \\ pv = nrt \\ v = \frac{nrt}{p} \\ v = \frac{.25 \times .082 \times 300}{1} \\ = \frac{1}{4} \times 8.2 \times 3 \\ = 2.05 \times 3 \\ = 6.15litre \\ thank \: you[/tex]

Answer:

The momentum is then (10 kg)(5 m/s)= 490.5 kg-m/s

Explanation:

Answer is A

Answer: It is either C. or D.

Explanation: I did some reading about it and it talks about fuel but I know that it didn’t say all of them are used as fuels.  maybe I’m wrong

Petroleum is composed of hydrocarbons of various chain length. Different products can be extracted from petroleum but all products cannot be used as fuel.

Hydrocarbons in diesel have higher boiling point than that of gasoline.

Petroleum is a naturally occurring crude liquid mixture of hydrocarbons. Petroleum can be fractionated to different components such as gasoline, kerosene, diesel etc.

Each fraction vary in the number of carbons and hydrogens in it or called the difference in chain length. Kerosene contains 8-16 carbons where as gasoline and diesel have more carbons.

Not all products of petroleum fractionation can be used as fuel. Some of them with effective quality is taken as fuels.

The boiling point of hydrocarbons in diesel is greater (about 130-380 degree Celsius) than the hydrocarbons in gasoline which is having boiling point in he range 30-225 degree Celsius.

Therefore, the statement C is correct.

To learn more about petroleum, find the link below:

https://brainly.com/question/4147953

#SPJ5

Answer:

All zeros between other significant digits are significant. The number of significant figures is determined by starting with the leftmost non-zero digit. The leftmost non-zero digit is sometimes called the most significant digit or the most significant figure. For example, in the number 0.004205, the '4' is the most significant figure.

Explanation:

PA BRAINLIEST

HOPE ITS HELP

GOD BLESS

Answer:

2 moles of C and no more

Explanation:

Consider the following reaction: 2A + 3B --> 2C If you have 2 moles of A and 6 moles of B, what is the maximum number of moles of C that can be made by the reaction

2A + 3B --> 2C '

2 of A make 2 of C if we have atleast 3 of B.

we ave more than enough B

2 of A will make 2 moles of C and no more

Answer:

The gas that was produced by the reaction of zinc and hydrochloric acid was Hydrogen gas and zinc chloride. In the presence of fire, hydrogen explodes with a popping sound. The popping sound put out the flame.

When Zn is reacts with HCl then generating tiny hydrogen bubbles as well as creating zinc chloride [tex]ZnCl_{2}[/tex] (zinc chloride).

A process known as the hydrogen bubble procedure electrolyzes conductive water containing acid / base to produce hydrogen bubbles.

[tex]ZnCl_{2}[/tex] (zinc chloride) will be formed by the reaction between the Zn (Zinc) and Cl (chlorine).

It can be written as:

[tex]Zn +Cl_{2}[/tex] → [tex]ZnCl_{2} +H_{2}[/tex].

Hence, [tex]ZnCl_{2}[/tex] (zinc chloride) and hydrogen gas will be formed during the reaction.

To know more about hydrogen bubbles.

https://brainly.com/question/12708099

#SPJ3

identify keys concepts/terminologies about solutions or concentration of solutions.

They are the two basic solution concentration terms that you need to know.We always need to keep an account of the amount of solute in a solution.The amount of solute in the solvent is what is called the concentration of a solution.In chemistry,we define concentration of solution as the amount of solute in a solvent.

Depending upon amount of solute present,it is called a dilute, concentrated or a saturated solution.Different substances in a given solvent have a different solubilities at the same temperature.The most common method for expressing the concentration of a solution is the percentage method

Answer:

40 hopefully right

Explanation:

Answer:

Explanation:

Determine the treatments you’ll be using on your eggs, and prepare the substances you’ll need. You can make salt-water solutions by dissolving different amounts of table salt in containers of water (e.g. 100g, 200g, 300g of salt (NaCl) per liter). You can make solutions of food coloring by adding a few drops of each color into containers of  

The Eggsperiment with Vinegar solution. The first experiment conducted was the egg placed in vinegar solution which allowed the egg to become soft and bouncy . Vinegar is a weak acid which is 5% acetic acid in water (meaning vinegar is largely just water). The egg has a shell that is made up of calcium carbonate   an air cell forms at the large end of the egg. While the embryo is growing, the shell membranes surround and contain the white or albumen of the egg. The albumen provides the liquid medium in which the embryo develops, and it also contains a large amount of the protein necessary for proper development. I hope this was hopeful

Answer:

that would just create a bigger mess if you flush it with ice water it can reduce swelling and help dull your nerves

Explanation:

If acid comes in contact with your skin, because having an excessive amount of base can also be harmful. Acid is weakened and rendered ineffective by water.

A chemical species known as an acid absorbs electrons and/or provides protons or hydrogen ions. When a hydrogen atom is bound to an acid, it can release (dissociate) and produce a cation as well as an anion in water. A substance's acidity and solution pH increase according to the amount of hydrogen ions it produces.

There are various definitions for acids. When someone uses the term "an acid," they typically mean an Arrhenius or Brnsted-Lowry acid. Often, a Lewis acid being referred to as a "Lewis acid." If acid comes in contact with your skin, because having an excessive amount of base can also be harmful. Acid is weakened and rendered ineffective by water.

Therefore, if acid comes in contact with your skin, because having an excessive amount of base can also be harmful. Acid is weakened and rendered ineffective by water.

To know more about acid, here:

https://brainly.com/question/29796621

#SPJ3

Explanation:

the chemicals are group 7 elements and one of their characteristics is that the melting and boiling point increase progressively

In this case, according to the Raoult's law, we can find the mole fraction of 79 wt% benzene and 21 wt% toluene at 50 °C in the vapor phase as follows:

[tex]y_iP=x_iP_i[/tex]

However, we first have to calculate the mole fractions in the solution as follows (b stands for benzene and t for toluene):

[tex]\\x_b=0.79\frac{g\ benzene}{g\ solution} *\frac{(78.11*x_b+92.14*x_t)}{1mol\ solution} *\frac{1mol\ toluene}{78.11g\ toluene} \\\\x_b=0.79\frac{g\ benzene}{g\ solution} *\frac{78.11*x_b+92.14*(1-x_b)}{1mol\ solution} *\frac{1mol\ toluene}{78.11g\ toluene}\\\\x_b=0.79*(x_b+1.18*(1-x_b))\\\\x_b=0.79x_b+0.932-0.932x_b\\\\x_b=\frac{0.932}{1+0.932-0.79} =0.816\\\\x_t=1-x_b=1-0.816=0.184[/tex]

Next, we calculate the total pressure as follows, according to the Dalton's law:

[tex]P=x_bP_b+x_tP_t=0.816*271mmHg+0.184*91.5mmHg=237.972mmHg[/tex]

Finally, the mole fractions of the vapor phase turn out:

[tex]y_b=\frac{0.816*271mmHg}{237.972mmHg}=0.929\\\\y_t=1- 0.929=0.071[/tex]

Learn more:

Answer:

Rb, Zn, P, S, F, Ca, Co, Cr

Rb, Zn, P, S, F, Ca, Co, Cr elements in order of decreasing metallic character.

The metallic character of an element is defined as the properties typical of metal, especially the tendency to lose electrons in chemical reactions.

Metallic character depends on the ability of an element to lose its outer valence electrons. Examples of properties related to metallic character include thermal and electrical conductivity, metallic lustre, hardness, ductility, and malleability. The most "metallic" element is francium, followed by caesium.

Hence, Rb, Zn, P, S, F, Ca, Co, and Cr elements in order of decreasing metallic character.

Learn more about the metallic character here:

https://brainly.com/question/25500824

#SPJ2

Answer:

The plum pudding model would have to be true as well because it shows that electrons are scattered within an atom.

Explanation:

I took the test and got it right :)

The plum pudding model would have to be true as well because it shows that electrons are scattered within an atom

The model of the atom proposed by Rutherford is called the nuclear model of the atom called the nuclear model of the atom. It was proposed after his famous experiment using a thin gold foil.

His previous prediction was that the alpha particles will bend or deflect around the positively charged areas of the gold atom. If this prediction came true, the plum pudding model would have to be true as well because it shows that electrons are scattered within an atom.

Learn more: https://brainly.com/question/25105283

Answer:

Hydrogen

Electronic notation

Explanation:

The alkaline earth element with the least massive atoms is beryllium (Be). Beryllium, located in Group 2 of the periodic table, possesses the lowest atomic number and atomic mass within the alkaline earth elements.

Among the alkaline earth elements, which are found in Group 2 of the periodic table, beryllium (Be) stands out for having the least massive atoms. The periodic table is organized in a way that elements are ordered by increasing atomic number, which corresponds to the number of protons in an atom's nucleus. For alkaline earth elements, the atomic numbers increase from beryllium (Be) with atomic number 4 to radium (Ra) with atomic number 88.

Atomic mass, on the other hand, takes into account the sum of protons and neutrons in an atom's nucleus, as electrons contribute very little to the overall mass. Since beryllium (Be) has the lowest atomic number in the alkaline earth group, it also has the fewest protons and neutrons among its isotopes, leading to a lower atomic mass compared to other elements in the same group.

To learn more about periodic table

brainly.com/question/28747247

#SPJ3

Answer:

You have to write the full question

Answer:

red bone marrow contains blood stem cells that can become red blood cells ,white blood cells ,or platelets

Explanation:

Answer: 3.2 [D]

Explanation:

Use Boyles law

(Might want to rotate image, sorry!)

Answer:

k im silly frrr lol have a great day

Answer:

34 grams

Explanation:

Assuming m/v means mass of solute / volume of solvent, then set up the equation:

1.7/100=m/2000, by cross multiplication, m=34 grams

Answer:

C6H5S^-

Explanation:

This is because you are removing the hydrogen to make it a conjugate base.

The formula for conjugate base of C6H5SH is C6H5S⁻.

Conjugate base is defined as the substance which is formed when an acid liberate its protons.

The acid donate protons and the acid changes into base.

Conjugate acid is defined as the pair of compound that differs by its protons by gaining protons.

Conjugate acid and base are based in acid base theory.

Thus, the formula for conjugate base of C6H5SH is C6H5S⁻.

To learn more about conjugate base, refer to the link below:

https://brainly.com/question/12883745

#SPJ2

Answer: mixture

Explanation: they are heterogeneous mixtures not homogeneous

It's Mixture

Reason:- Dirty water is a mixture of dirt and water. Mixture are made up of 2 or more different substance with different characteristics

For a weak intermolecular bond, both the melting point and boiling point are lower.

A lesser energy is required to break bond of weak intermolecular forces while a greater energy is required to break bond of strong intermolecular forces.

E ∝ T

where;

A lesser energy means a lower temperature and a lower temperature will result in lower boiling point and melting point.

Thus, we can conclude that for a weak intermolecular bond, both the melting point and boiling point are lower.

Learn more here:https://brainly.com/question/14719148

Answer:

see below

Explanation:

1. particle motion

2. The particles of a liquid can slide past one another.

3. the kinetic energy required to break forces between particles

4. increasing its temperature until it transitions from a solid to a liquid

5. A liquid becomes a gas.

[quizlet: captncrun]

Thermal energy is in the form of heat and light is always associated with the random motion of atoms and molecules. That form of kinetic energy is used to the rise in temperature.

Hence the option B is correct.

Learn more about the Thermal energy is associated with.

brainly.com/question/16953428.

Answer:

3O2→ 2O3

Explanation:

by multiplying 2 by 3 we get 6 on both sides