The following diagram shows a single cell. Is the cell eukaryotic or prokaryotic? Explain your reasoning

The correct name of HNO₂, HI and of H₃PO₄ is nitrous acid, hydroiodic acid and phosphoric acid respectively.

Acids are those substances in which carboxylic acid (-COOH) is present and pH value of acids falls in the range of 0 to 6.9.

Name of the HNO₂ compound is nitrous acid, of HI is hydroiodic acid and of H₃PO₄ is phosphoric acid.

Hence name of the HNO₂, HI and of H₃PO₄ is nitrous acid, hydroiodic acid and phosphoric acid respectively.

To know more about acids, visit the below link:

https://brainly.com/question/24375075

#SPJ2

Answer: HNO2 nitrours acid

              HI Hydroiodic acid

               H3PO4 phosphoric acid

Explanation: edu

Answer:

D. passing an electric current through water to form hydrogen and oxygen

Explanation:

only one that's not just a physical change.

Answer:

It have lower mass because much of the ashes came from the burned wood. (ashes were like little parts of the wood). plus most of the fuel was turned in to fire (light and heat energy) so yeah ash is just the left over.

Explanation:

Answer:

Kindly check the explanation section.

Explanation:

PS: Note that enough information are not being provided and we do not know the experiment this question is all about. However, some information are provided below which is going to aid in solving when you get access to the main question.

The determination of the heat transferred from one substance to another is one of the important aspect in science. The method in which this heat is being measured is known as calorimetry and the instrument used in this technique is known as the calorimeter.

When the energy content of a snack is needed to be calculated, there is the need use a type of instrument known as bomb calorimeter.

Most of the calorimeters used by students are not so expensive like the used in the industries. Most of these calorimeters operates at a constant pressure while the Bomb Calorimeter operates at constant volume.

Answer:

Correct

Explanation:

According to the balanced chemical reaction, 2 mol FeBr3 are consumed for every 3 mol Na2S consumed.

A balanced equation obey the law of conservation of mass. The coefficients are the numbers which are added to balance the chemical equation. Here the given mole ratio is correct.

An equation in which the number of atoms of reactants and products on both sides of the equation are balanced is defined as the balanced chemical equation. The coefficients which are added in front of the formula of each component represents the number of the species.

A molar ratio denotes the ratio between the amounts in moles of any two compounds involved in a balanced chemical reaction. By comparing the coefficient of each component, the mole ratio can be determined.

Here for the given reaction, for every 3 moles of Na₂S consumption 2 moles of FeBr₃ is also consumed. So the molar ratio of Na₂S to FeBr₃ is 2/3. Molar ratios are used as the conversion factors between products and reactants in many chemistry problems.

To know more about mole ratio, visit;

https://brainly.com/question/29095152

#SPJ7

Answer:

1.) protons or electrons 2.) ion

Explanation:

Answer:

disagree

sometimes they attract

Explanation:

Answer:

Explanation:

2. Agree

3. Agree

4. Agree

5. agree

6. disagree

If im wrong its because im tired lol

Answer:

Bottle Nose Dolphin ummmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmm

Explanation:

Answer:

I think it's 2

Explanation:

The magma gets so hot, it floats up before cooling and sinking again

Answer:

(14.5 mol) x (6.022 x 10^23 atoms/mol) = 8.73 × 10^24 atoms

Explanation:

pls mark brainliest

Answer:

20.02 grams of chalk.

Explanation:

Answer:

200 lb•ft/s

Explanation:

From the question given above, the following data were obtained:

Force (F) = 2 tons

Time (t) = 5 mins

Height (h) = 15 ft

Power (P) =?

Next, we shall convert 2 tons to pound. This can be obtained as follow:

1 ton = 2000 lb

Therefore,

2 tons = 2 × 2000

2 tons = 4000 lb

Next, we shall convert 5 mins to seconds. This can be obtained as follow:

1 min = 60 s

Therefore,

5 mins = 5 × 60

5 mins = 300 s

Finally, we shall determine the power of the pump. This can be obtained as follow:

Force (F) = 4000 lb

Time (t) = 300 s

Height (h) = 15 ft

Power (P) =?

P = F × h / t

P = 4000 × 15 / 300

P = 60000 / 300

P = 200 lb•ft/s

Thus, the power of the pump is 200 lb•ft/s

Answer:

It's 200 ft-lb/sec

Explanation:

I did it before!

Answer:

3.36 M

Explanation:

Step 1: Given data

Step 2: Calculate the moles (n) of CuSO₄.6H₂O (solute)

We will use the following expression.

n = m/M

n = 25.2 g / (267.72 g/mol) = 0.0941 mol

Step 3: Calculate the molarity

Molarity is equal to the moles of solute divided by the liters of solution.

M = 0.0941 mol/0.0280 L = 3.36 M

Answer:

Single replacement reaction

Explanation:

A single replacement reaction, sometimes called a single displacement reaction, is a reaction in which one element is substituted for another element in a compound.

Answer:

323 K

Explanation:

To convert Celcius to kelvin first you need to remember this equation:

C + 273 = K (K = kelvin and C = celsius)

Next, you substitute with what you have given:

50 + 273 = K

Solve the equation by adding 50 and 273

k = 323

Answer: [tex]H_2SO_4[/tex] is the limiting reagent.

Explanation:

A double displacement reaction is one in which exchange of ions take place. The salts which are soluble in water are designated by symbol (aq) and those which are insoluble in water and remain in solid form are represented by (s) after their chemical formulas.  

The balanced chemical equation is:

[tex]3H_2SO_4(aq)+2Al(OH)_3(aq)\rightarrow Al_2(SO_4)_3(aq)+6H_2O(l)[/tex]

To calculate the moles :

[tex]\text{Moles of solute}=\frac{\text{given mass}}{\text{Molar Mass}}[/tex]    

[tex]\text{Moles of} H_2SO_4 =\frac{30g}{98g/mol}=0.31moles[/tex]

[tex]\text{Moles of} Al(OH)_3=\frac{25g}{78g/mol}=0.32moles[/tex]  

According to stoichiometry :

3 moles of [tex]H_2SO_4[/tex] require = 2 moles of [tex]Al(OH)_3[/tex]

Thus 0.31 moles of [tex]H_2SO_4[/tex] will require=[tex]\frac{2}{3}\times 0.31=0.21moles[/tex]  of [tex]Al(OH)_3[/tex]

Thus [tex]H_2SO_4[/tex] is the limiting reagent as it limits the formation of product and [tex]Al(OH)_3[/tex] is the excess reagent.

Answer:

13.2% Mg, 86.8% Br

Explanation:

Mg has a molar mass of 24.31g/mol.

Bromine has a molar mass of 79.90 g/mol.

There is one mole of Mg and two moles of Br in the compound:

79.90x2 + 24.31 = 184.11

So the total molar mass of MgBr2 is 184.11.

A percent tells us a part of a whole, so we will divide each part of the mass into the whole mass.

24.31g Mg / 184.11g MgBr2 = .132

159.8g Br / 184.11g MgBr2 = .868

Multiply these decimals by 100 to make them into a percent.

.132 x 100 = 13.2% Mg

.868 x 100 = 86.8% Br

Answer:

i just had a test on this with 2 attempts and got it wrong on both but i do know that the answer is not...

the steepness of the models hillside

or

the rate of erosion on the hills

so the answer is either...

the amount of water sprayed on the hills

or

the type of material used to construct the model hills

but i think its the amount of water sprayed on the hills...i hope i helped a lil ;)

Explanation:

Answer:

A. Metallic Bonds

Explanation:

Metallic bonding is a type of chemical bonding that arises from the electrostatic attractive force between conduction electrons and positively charged metal ions.

Answer:

pH≈1.35

Explanation:

-log(0.045)≈1.35

Answer:

By closely observing the sedimentary rock and the presence of organic materials and mineral grains in sedimentary rocks

Explanation:

The rock cycle explains how the three types of rock are formed over time from each other.

To use a sedimentary rock to prove that the rock cycle is a valid scientific model is by, closely observing the sedimentary rock. when the sedimentary rock is closed observed the principle of superposition will be seen ( i.e. younger segments deposited on top ), the presence of organic materials and mineral grains that can be found in Igneous or Metamorphic rocks can also be seen and this shows that Sedimentary rocks pass through the rock cycle. hence this proves that the rock cycle is a valid scientific model overtime  

Answer:

it is a chemical change because it can't be change back to it normal position when it gets burnt

Answer:

uh oh stinky uh oh stinky