The rate of reaction between two gases increases when the temperature is increased and a catalyst is added. Which statements correctly describe the effect on the reaction?

I. Increasing temperature increases collision frequency
II. Increasing temperature decreases activation energy
III. Adding a catalyst increases the activation energy requirement
IV. Adding a catalyst decreases the activation energy requirement

Group of answer choices

I and III

II and IV

I and IV

II and III

Answer:

3,550,000

Explanation:

3 significant figures is a number which has 3 figures

and zeros ( zero is not a figure )

Answer:

3550,000

Explanation:

Rounding rule:

If > 5 enter one

If < 5 rounding

Note:

< = less than

> = greater than.

Solve:

Base on the given:

it < 5 rounding

Thus,

3545,530 ≈ 3550,000

~Lenvy~

Answer:

Measure so that the line you are reading is even with the center of the meniscus. For water and most liquids, this is the bottom of the meniscus. For mercury, take the measurement from the top of the meniscus. In either case, you are measuring based on the center of the meniscus.

Explanation:

Answer:

Animals also contribute to mechanical weathering. Digging animals such as moles break apart rocks underground, while the movement of animals on surface rock can scratch the rock's surface or exert pressure that causes the rock to crack.

Explanation:

pls brainlist me, correct me if I'm wrong

Suppose 5.0 mol of antimony (III) fluoride is added to 10.0 mol of carbon tetrachloride, and from the 100% reaction there are the equivalents of 0 moles of SbF₃, 5.0 moles of SbCl₃, 0 moles of CCl₄, and 15.0 moles of CClF₂.

A balanced reaction is one where the reactants and products are present in equal amounts, and if the 100% reaction takes place, then the reactant sides have 1 mol of SbF₃ and 3 mol of CCl₄ that make the product of 1 mol of SbCl₃ and 3 mol of CClF₂. After the 100% reaction, all the reactants get converted into the product. The complete reaction is the below.

SbF₃ + 3CCl₄ → SbCl₃ + 3CClF₂

Hence, suppose  5.0 mol of antimony (III) fluoride is added to 10.0 mol of carbon tetrachloride, and from the 100% reaction there are the equivalents of 0 moles of SbF₃, 5.0 moles of SbCl₃, 0 moles of CCl₄, and 15.0 moles of CClF₂.

Learn more about the balanced reaction here.

https://brainly.com/question/14280002

#SPJ2

Answer:

The enthalpy of vaporization of a given substance is much greater than its enthalpy of fusion because it takes more energy to completely separate molecules (c

The value of Avogadro's number was obtained by dividing the charge of a mole of electrons by the charge of a single electron which is equal to 6.02214154 x 1023 particles per mole.

The most common used way is

There can be another derived way

Here is a Answer to your question:

Air pollution is caused by solid and liquid particles and certain gases that are suspended in the air. These particles and gases can come from car and truck exhaust, factories, dust, pollen, mold spores, volcanoes and wildfires. The solid and liquid particles suspended in our air are called aerosols.

Here are the 8 causes of air pollution?

1: The Burning of Fossil Fuels

2: Industrial Emission

3: Indoor Air Pollution

4: Wildfires

5: Microbial Decaying Process

6: Transportation

7: Open Burning of Garbage Waste

8: Construction and Demolition

I am sorry if this was not helpful

Hope this was helpful

Answer: 1. Ions

2. Cation

Explanation:

No explanation; this is basic vocabulary. :)

Answer:

Activation energy :)

Explanation:

The activation energy starts the reaction! Without it, we would not find out the solution!

Have an amazing day!!!

Please rate and mark brainliest!!

Answer:

b. nuclear fuel has a higher energy density than fossil fuels.

Explanation:

Nuclear fuel is a quantity of energy measured in joules; therefore, it has the same units as electrical and mechanical energy.

Answer:

Lithium has high melting and boiling point due to its small size, due to which it possesses high ionisation energy. As a result the binding energy in its crystal lattice is very high. This is why lithium has high melting and boiling point.

Explanation:

I HOPE IT HELPS! THANX!!

STAY SAFE!!!

The molarity of a solution that has 0.05 moles of HCL are added to 2 L of H2O is 0.025M.

The molarity of a solution can be calculated using the following formula:

M = n/V

Where;

M = 0.05/2

Molarity = 0.025M

Therefore, the molarity of a solution that has 0.05 moles of HCL are added to 2 L of H2O is 0.025M.

Learn more about molarity at: https://brainly.com/question/12127540

Answer:

The acid reacts with the mineral to release CO2 gas that is bound into the crystal as carbonate ion.

Explanation: i got it corrcet

Answer:

Fiddlehead

Explanation:

Young fronds are called Fiddleheads

because of how they are coiled

Answer:

Fiddleheads or koru

Explanation:

The coiled, immature leaves are called fiddleheads. Young fronds, called fiddleheads because of their striking resemblance to the head of a violin, start out tightly curled at the base of the root. New, or young fronds are produced from the rhizome. They are tightly coiled into a spiral (called a fiddlehead or koru), and these slowly uncoil as they mature.

Fuel shortages in the 1980s started the interest in fuel efficiency  best describes a society’s desire for fuel-efficient vehicles because of Iran- Iraq war.

The Iran-Iraq War in 1980 is the main cause of shortage of oil production. Iraq's and Iran's oil production dropped significantly which triggering economic recessions worldwide.

So that's why society’s desire for fuel-efficient vehicles in order to reduce consumption as well as reduce pollution.

Learn more about fuel here: https://brainly.com/question/25870707

The mass of nickel, Ni deposited when 0.2 faraday of electrical charge is passed through a solution of NiSO₄ is 5.9 g

Ni²⁺ + 2e —> Ni

Molar mass of Ni = 59 g/mol

Mass of Ni from the balanced equation = 1 × 59 = 59 g

Number of faraday = 2

SUMMARY

From the balanced equation above,

2 faraday deposited 59 g of Nickel

From the balanced equation above,

2 faraday deposited 59 g of Nickel

Therefore,

0.2 faraday will deposit = (0.2 × 59) / 2 = 5.9 g of Nickel

Thus, 5.9 g of Nickel were deposited in the process

Learn more about Faraday's law:

https://brainly.com/question/24795850

Answer:

5.9 grams

Explanation:

You need 2 faraday to deposit 1 mole of Ni (59 grams) because there are 2 moles of electrons in equation:

Ni+2 + 2e- --> Ni(s)

So, 0.2 faraday will deposit 1/10 of that or 5.9 grams of Ni(s).

Answer:

Mammals do not have instincts, so they must learn all their behaviors from their parents in order to survive.

Sea turtles must survive on their own, while mammals spend time with their parents and learn how to survive as they grow.

Sea turtles are less intelligent than mammals and, thus, cannot learn new behaviors from their parents.

Explanation:

Sea turtles rely on instincts more than mammals do, beacuse to get food for their survival.

Insticts are the natural impulse or motivation which are present from the inborn time to perform some functions in order to react in some specific external stimuli.

Mammals do not react impulsively in any external conditions because they have members or friends from their famliy side, who will teach them how to behave or react. But turtles didn't have that special person, so they do work rely on instincts to get food or many other purposes.

Hence, to survive sea turtles rely on instincts more than mammals do.

To know more about insticts, visit the below link:

https://brainly.com/question/16088051

Answer:

16.015668 M

Explanation:

Concentration is mols/L

nacl molar mass is 58.44277 g/mol

moles = mass/molar mass

moles = 4.00391699

4mol/0.250L = 16.015668 M solution

The concentration of NaOH that is used to completely neutralize is 0.25 Liters.

We will calculate the concentration in terms of molarity by using the below formula:

M₁V₁ = M₂V₂, where

M₁ = molarity of H₂SO₄ = 2m

V₁ = volume of H₂SO₄ = 0.25 L

M₂ = molarity of NaOH = ?

V₂ = volume of NaOH = 2 L

On putting all these values on the above equation, we get

M₂ = (2)(0.25) / (2) = 0.25 L

Hence required volume is 0.25 L.

To know more about molarity, visit the below link:
https://brainly.com/question/26873446

Answer:

9.5

Explanation:

that the answer I hope am correct

Answer:

The answer is (3) 1676 kJ. The heats of reaction at 101.3 kPa and 298 K for reaction: 4Al(s) +3O2(g)= 2Al2O3(s) is -3351 kJ. So for one mole of aluminum oxide is 3351/2=1676 kJ.

D. Water

Answer:

Single replacement is a reaction in which one element reacts with another compund to form another compound and another element.

planation:

If the reaction is double displacement then two molecules will be displaced and if it is single displacement reaction then only one element displaces.

Displacement reactions are those reactions in which any element of the given reactant will be displaced by any another element.

If only one element from the reactant molecules will displace then it will be known as single displacement reaction. If two elements or atoms will be displaced from the reactant molecules then it will be known as double displacement reaction.

Hence if one element displaceed then called the single displacement reaction and if two elements displaces then called as the double displacement reaction.

To know more about displacement reactions, visit the below link:

https://brainly.com/question/13328989

The amount of heat transferred in and out of the system is measured by calorimetry. The thermometer in the calorimeter is used to measure the temperature.

The thermometer (A) is a device used to measure the final and the initial temperature of the water or any other liquid in a system. A metal vessel is a place where the reaction mixture is present.

In-vessel (B), water, and metal are placed before the beginning of the experiment. The styrofoam cup or the outer metal vessel (C) insulates the instrument, from regulating the heat transformation.

Therefore, part A measures the temperature of the reaction mixture.

Learn more about insulated containers here:

https://brainly.com/question/866735

Answer:

0.01134kg

Explanation:

You divide by 1000 to get the kg

To calculate the molar volume of a gas at STP you can use the ideal gas law equation,

PV=nRT

Regardless of what ideal gas you use, the molar volume at STP will be identical across the board, since you'll be using 1 mole in the ideal gas law equation regardless of what gas you're dealing with.

That is why the volume occupied by 1 mole of any ideal gas will be equal to 22.7 L at STP.

22.4L = 1 mol

38.0L = ?

= 38/22.4

=1.6964285714 Moles

Answer:

Pb(NO

3

)

2

+

2

KI

→

PbI

2

+

2

KNO

3

Explanation:

Isotopes are only formed in laboratories and is denoted as option D.

This refers to an element which has the same atomic number but different mass number due to difference in number of neutrons.

They are also usually formed in laboratories through series of chemical reactions.

Read more about Isotopes here https://brainly.com/question/6258301

#SPJ1

The pH of a 0.50M solution of malic acid with ka1 = 4. 0 × 10-⁴ and ka2 = 6. 3 × 10-⁶ as described is; 1.85.

Since, in a polyprotic acid the first hydrogen will dissociate faster than the others, If the Ka values differ by a factor of 10-³ or more, it is possible to approximately calculate the pH by using only the Ka of the first hydrogen ion.

However, the situation is different in this scenario.

On this note, the solution is as in the attached image.

Read more on Diprotic acids;

https://brainly.com/question/26015203

The pH of a 0.50 m solution of malic acid is 1.85.

pH is potential hydrogen. It is the measurement of the acidity and basicity of any solution.

The ka1 = 4. 0 × 10⁻⁴

The  ka2 = 6. 3 × 10⁻⁶

The solution is 0.50 m.

First calculate the ka value

[tex]ka = \dfrac{x^2}{0.50} \\\\x^2 = 0.50 \times 4 \times 10^-^4\\\\x^2 = 2 \times 10^-^4\\x^2 = \sqrt{2 \times 10^-^4} \\\\ x = [H^+] = 1.41 \times 10^-^2[/tex]

Now, calculate the pH

[tex]pH = -log [H^+]\\\\pH = -log[ 1.41 \times 10^-2]\\\\pH = 1.85[/tex]

Thus, the pH of a 0.50 m solution of malic acid is 1.85.

Learn more about pH

https://brainly.com/question/15289741

#SPJ4