Answer:
Red is the lowest.
Explanation:
How do we know if molecules have kinetic energy?
If the temperature of a chemical reaction was reduced, how could the reaction rate most likely be increased?
Group of answer choices
decrease the pressure acting on the system
add a chemical inhibitor
decrease the surface area of the reactants
increase the concentration of the reactants
Answer:
Increase the concentration of the reactants.
Explanation:
This question seems vague, but to put it simply, the reaction rate decreases with a decrease in temperature, so we need to find a way to increase the reaction rate again. When you lower temperature, the molecules are slower and collide less. So therefore, in other words, we need to find a way to increase the rate of collisions between molecules. When the temperature drops, if we increase the concentration of the reactants, we are able to increase the rate of collisions between molecules. As a result, reaction rate is increased once again.
If the temperature of a chemical change was reduced,the reaction rate could most likely be increased by increasing the concentration of the reactants.
What is a chemical change?Chemical changes are defined as changes which occur when a substance combines with another substance to form a new substance.Alternatively, when a substance breaks down or decomposes to give new substances it is also considered to be a chemical change.
There are several characteristics of chemical changes like change in color, change in state , change in odor and change in composition . During chemical change there is also formation of precipitate an insoluble mass of substance or even evolution of gases.
There are three types of chemical changes:
1) inorganic changes
2)organic changes
3) biochemical changes
During chemical changes atoms are rearranged and changes are accompanied by an energy change as new substances are formed.
Learn more about chemical change,here:
https://brainly.com/question/2591189
#SPJ6
Which particles make up most of the mass of an atom?
i think Neuterons i am right
Answer:
I do not know srry
Explanation:
What are resistors? please help
Answer:Resistor Basics
Resistors are electronic components which have a specific, never-changing electrical resistance. The resistor's resistance limits the flow of electrons through a circuit.
They are passive components, meaning they only consume power (and can't generate it). Resistors are usually added to circuits where they complement active components like op-amps, microcontrollers, and other integrated circuits. Commonly resistors are used to limit current, divide voltages, and pull-up I/O lines.
Resistor units
The electrical resistance of a resistor is measured in ohms. The symbol for an ohm is the greek capital-omega: Ω. The (somewhat roundabout) definition of 1Ω is the resistance between two points where 1 volt (1V) of applied potential energy will push 1 ampere (1A) of current.
As SI units go, larger or smaller values of ohms can be matched with a prefix like kilo-, mega-, or giga-, to make large values easier to read. It's very common to see resistors in the kilohm (kΩ) and megaohm (MΩ) range (much less common to see miliohm (mΩ) resistors). For example, a 4,700Ω resistor is equivalent to a 4.7kΩ resistor, and a 5,600,000Ω resistor can be written as 5,600kΩ or (more commonly as) 5.6MΩ.
Schematic symbol
All resistors have two terminals, one connection on each end of the resistor. When modeled on a schematic, a resistor will show up as one of these two symbols:
Resistor schematic symbols
Two common resistor schematic symbols. R1 is an American-style 1kΩ resistor, and R2 is an international-style 47kΩ resistor.
The terminals of the resistor are each of the lines extending from the squiggle (or rectangle). Those are what connect to the rest of the circuit.
The resistor circuit symbols are usually enhanced with both a resistance value and a name. The value, displayed in ohms, is obviously critical for both evaluating and actually constructing the circuit. The name of the resistor is usually an R preceding a number. Each resistor in a circuit should have a unique name/number. For example, here's a few resistors in action on a 555 timer circuit:
Answer: resistor is
Explanation:
A resistor controls the flow of the electrical current within a circuit. Resistors are made from materials like copper or carbon, which make it difficult for the electrical charges to flow through a circuit. The most common type of resistor is a carbon resistor, which is a general purpose resistor, best suited for lower-powered circuits.
Students report that the sky in their area has mostly cirrus clouds. What are most likely the weather conditions in the area?
rainy weather
dark, overcast (blocking the sunlight)
stormy weather
fair, pleasant weather
Why does a DNA fingerprint require millions of copies of each DNA fragment
Answer:
Because it can identify a person.
A DNA fingerprint is a piece of DNA so distinct that it can prove a person's identity. These distinct areas can take on many different forms, but each form is unique to any one individual.
PCR allows the amplification of a single copy of DNA into millions of copies. However this technique requires that the DNA of interest already be of a known sequence in order to design primers that will specifically hybridize to the target DNA.
It is important as:
It's used as evidence in courts, to identify bodies, track down blood relatives, and to look for cures for disease.
Learn more:
brainly.com/question/13695548
The mass of an object is measured in grams or kilograms TRUE OR FALSE
Answer:
True
Explanation:
The bigger mass is measured in kilograms and smaller in grams
What happened during the fusion reaction shown?
Answer:
the answer to this question B. Two H nuclei that fused into one He necleus
Explanation:
Two hydrogen atoms fused to one helium molecule, hence option B is correct.
What is fusion?Fusion is defined as a process in which two or more atomic nuclei unite to create new atomic and subatomic particles. Heat, which is produced when two atoms fuse, is the key to generating energy. Similar to how nuclear fission produces energy, this heat can be utilized to warm water, produce steam, and turn turbines to produce electricity.
In the core of the Sun, hydrogen is being converted to helium. This phenomenon is known as nuclear fusion. Fusion is what powers both the sun and the stars. One example of this kind of reaction is when two hydrogen atoms combine to form a helium atom. During the process, a portion of the hydrogen's mass is converted into energy.
Thus, two hydrogen atoms fused to one helium molecule, hence option B is correct.
To learn more about fusion, refer to the link below:
https://brainly.com/question/12701636
#SPJ2
What is the molarity of a solution made by diluting 0.025L of 6.0 M HCl until
the final volume of the solution is 1.75 L?
Answer:
Explanation:
Use the dilution equation: M1V1 = M2V2
M1 = 6.0 M
V1 = 0.025 L
M2 = ?
V2 = 1.75 L
(6.0 M)(0.025 L) = M2(1.75 L)
Solve for M2 --> M2 = 0.086 M HCl
Calculate the volume occupied by 2.00 moles of H2 at 300.0 Kand 1.25
atm
Answer:
39.4 Liters
Explanation:
Using the general gas law equation as follows:
PV = nRT
Where;
P = pressure (atm)
V = volume (L)
n = number of moles (mol)
R = gas law constant (0.0821 Latm/molK)
T = temperature (K)
According to the information provided in this question;
P = 1.25atm
V = ?
T = 300K
n = 2.00mol
Using PV = nRT
V = nRT/P
V = (2 × 0.0821 × 300) ÷ 1.25
V = 49.26 ÷ 1.25
V = 39.41
V = 39.4 Liters
How many copies of DNA do haploid cells have
Answer:
2 lol
Explanation:
Where is the potential energy to run the plant?
A 3
B
4
С
1
D
2
Answer: C
Explanation:
your well wisher
what are some features of the deep sea vent ecosystem
(please help :) )!!!!!!!!!!!!!
Maybe this information is helpful:
The features of the ocean floor are not permanent, and are gradually changing over time due to the movement of tectonic plates. Most of the ocean floor features from close to where the plates are shifting either towards or away from each other. Marine ecosystems are found around parts of the ocean floor features, even the Mariana Trench, which is the deepest trench in the world.
3. How does genetic variation allow humans to survive long-term? Which
type of reproduction is responsible for genetic variation?
Answer:
more genetic variation within a population usually enables more phenotypic variation.
Explanation:
Because natural selection acts directly only on phenotypes, Some new alleles increase an organism's ability to survive and reproduce, which then ensures the survival of the allele in the population.
Genetic variation lets the organisms survive long term as it increases the phenotypic and the genotypic variation. Genetic variation is due to the type of reproduction that involves two parents.
What is genetic variation?Genetic variation is the modification of the original genome of the organism by genetic recombination and mutation that can be beneficial in the survival and the natural selection process.
Reproduction involving two parents of the same species allow genetic variation as the process of independent assortment and crossing over of the chromosomes inherited from both creates species with different traits and genotype.
Therefore, the reproduction involving two parents results in genetic variation.
Learn more about genetic variation here:
https://brainly.com/question/20665733
#SPJ2
why are metals poor choices for coffee mugs?
Answer:
They will stay too hot.
Explanation:
You would burn yourself on the mug and your drink would be too hot to drink.
Use the drop down menus to answer the questions. In what type of plate boundary did subduction occur? In what type of plate boundary did new crust form? In what type of plate boundary did mountains form? In what type of plate boundary did volcanoes form? In what type of plate boundary did a river change its path? Use the drop down menus to answer the questions. In what type of plate boundary did subduction occur? In what type of plate boundary did new crust form? In what type of plate boundary did mountains form? In what type of plate boundary did volcanoes form? In what type of plate boundary did a river change its path? Use the drop down menus to answer the questions. In what type of plate boundary did subduction occur? In what type of plate boundary did new crust form? In what type of plate boundary did mountains form? In what type of plate boundary did volcanoes form? In what type of plate boundary did a river change its path?
Answer:
the answers to this is Convergent, Divergent, Convergent, Convergent, and Transform
Explanation:
i just answered it :))
In different types of plate boundaries, various geological features occur such as volcano and mountain formation.
What are plate boundaries?Plate boundaries are the areas where the edges of two tectonic plates meet.
Plate boundaries can either be divergent, convergent, or transform.
At different plate boundaries, different geological activities occur.
At convergent plate boundaries, subduction occurs.At divergent plate boundaroes, new crust forms.At convergent plate boundaries, mountains form.At convergent plate boundaries, volcanoes form. At transform plate boundaries, a river change its path.Therefore, at different types of plate boundaries, various geological features occur.
Learn more about plate boundaries at: https://brainly.com/question/24519460
#SPJ5
determine the velocity of a cart traveling at 135cm in 5.5s.
Answer: 0.245 m/s
Explanation:
So velocity = d/t or distance over time in this case m/s or meters per second. But BE CAREFUL you must remember to convert cm to m always so 135 cm= 1.35m and 1.35m/5.5s= 0.245m/s
What happens when a chemical reaction reaches equilibrium
The unit of measure for potential and kinetic energy is the
Answer:
kilograms x meters2/seconds2
Explanation:
Answer:
kilograms x meters2/seconds2
Explanation:
Which type of cell would you expect to contain large amounts of mitochondria?
fat cells
muscle cells
liver cells
skin cells
muscle cells hope it helps
An object was measured by a worker as 35.6 cm long, however, the manufacturer specifications list the length of the object at 35.0 cm. What is the percent error in the workers measurement?
Please help!!! Will give brainlist
Which of the following describes wind direction?
Wind direction is reported by the direction from which it originates. For example, a north or northerly wind blows from the north to the south. Wind direction is usually reported in cardinal (or compass) direction, or in degrees.
Why do fossil fuels such as crude oil contain varying amounts of nitrogen and sulfur? Pls help
Answer:
See explanation
Explanation:
Fossil fuels are formed from the remains of plants and animals that have been subjected to intense pressure during the carboniferous era. These plants and animal remains undergo the process of fossilization to yield the fossil fuels we have today such as crude oil.
Living organisms are composed of elements which include nitrogen and sulphur. Since these fuels originated from dead organisms, they also contain these elements found in living organisms.
Hence, fossil fuels such as; coal, crude oil, and natural gas contain 0.05%-0.5% sulfur and 0.5%-2.1% nitrogen.
2. Mitosis is great for repair and damage. TRUE OR FALSE
Answer:
TRUE
HOPE THIS HELPS!
Explanation:
Answer:
True
Explanation:
Gas in a balloon occupies 3.3 liters. What volume will it occupy if the pressure is changed from 100 kPa to 90.0 kPa, if the temperature is held constant?
Answer:
3.7 L
Explanation:
Initial volume (V₁) = 3.3 L
Initial pressure (P₁) = 100 KPa
Final pressure (P₂) = 90 KPa
Final volume (V₂) =?
The final volume of the gas can be obtained by using the Boyle's law equation as follow:
P₁V₁ = P₂V₂
100 × 3.3 = 90 × V₂
330 = 90 × V₂
Divide both side by 90
V₂ = 330 / 90
V₂ = 3.7 L
Thus, the final volume of the gas is 3.7 L
Analyzing models compare an atom’s structure to a ladder. Identify one way in which ladder is not a good model from the atom.
Answer:
Climbing a ladder assumes that you would touch/use each step only once. Electrons will take one layer that is empty first, and previous layers or "steps" will continue being filled with additional electrons only when every other layer is occupied by, at least, one electron.
Explanation:
A good analogy is what passengers in a bus do. Everyone tries to sit alone first and only when every pair of seats has a person already seated, people will use them as well, sitting next to each other.
What is the proper name for the common sunflower
Answer: Helianthus L. Sunflower
Explanation:
Answer: Helianthus L.
Explanation:
TICLA ruuis SLCLLICU 10115CI.
Question 3 (1 point)
Which option correctly ranks the states of matter from slowest to fastest particle
speed.
gas, liquid, solid
solid, liquid, gas
solid, gas, liquid
gas, solid, liquid
What causes lava to not instantly melt ice sheets when it is poured onto it?
Answer:
Dry ice
Explanation:
Answer:
The lava doesn't melt through ice because the steam ice sits on top of a blanket of steam rather than on top of the ice itself. This means the friction between the lava and the ice is very low.
Explanation: