Write the IUPAC names for the following compounds.

Answer:

273.15 Kelvins

Explanation:

By decomposing 157g of NaCl, approximately 1.35 moles of chlorine can be produced.

To determine the number of moles of chlorine that could be produced by decomposing 157g of NaCl, we need to use the molar mass of NaCl and apply stoichiometry.

The molar mass of NaCl is the sum of the atomic masses of sodium (Na) and chlorine (Cl), which is approximately 22.99 g/mol + 35.45 g/mol = 58.44 g/mol.

Now, we can calculate the number of moles of NaCl:

Moles of NaCl = Mass of NaCl / Molar mass of NaCl

Moles of NaCl = 157 g / 58.44 g/mol

Moles of NaCl ≈ 2.69 mol

According to the balanced equation 2NaCl → 2Na + Cl₂, we can see that for every 2 moles of NaCl, we produce 1 mole of Cl₂.

Therefore, using the stoichiometric ratio, we can calculate the number of moles of chlorine produced:

Moles of Cl₂ = (Moles of NaCl / 2) × 1

Moles of Cl₂ = 2.69 mol / 2

Moles of Cl₂ ≈ 1.35 mol

Thus, by decomposing 157g of NaCl, approximately 1.35 moles of chlorine can be produced.

Learn more about chlorine from the link given below.

https://brainly.com/question/19460448

#SPJ2

The molarity of the NaOH solution is 0.03 M

We'll begin by calculating the mole of the KHP

Mole = mass /molar mass

Mole of KHP = 0.212 / 204.22

Mole of KHP = 0.001 mole

Next, we shall determine the molarity of the KHP solution

Molarity = mole / Volume

Molarity of KHP = 0.001 / 0.05

Molarity of KHP = 0.02 M

Finally , we shall determine the molarity of the NaOH solution

KHP + NaOH —> NaPK + H₂O

From the balanced equation above,

From the question given above, the following data were obtained:

MaVa / MbVb = nA / nB

(0.02 × 50) / (Mb × 35) = 1

1 / (Mb × 35) = 1

Cross multiply

Mb × 35 = 1

Divide both side by 35

Mb = 1 / 35

Mb = 0.03 M

Thus, the molarity of the NaOH solution is 0.03 M

Complete question:

See attached photo

Learn more about titration: https://brainly.com/question/25866669

Answer:

Gravity will always be pulling everything towards Earth's center at an acceleration of 9.81 m/sec².

Answer:

397 L

Explanation:

Recall the ideal gas law:

[tex]\displaystyle PV = nRT[/tex]

If temperature and pressure stays constant, we can rearrange all constant variables onto one side of the equation:

[tex]\displaystyle \frac{P}{RT} = \frac{n}{V}[/tex]

The left-hand side is simply some constant. Hence, we can write that:

[tex]\displaystyle \frac{n_1}{V_1} = \frac{n_2}{V_2}[/tex]

Substitute in known values:

[tex]\displaystyle \frac{(3.31 \text{ mol})}{(100 \text{ L})} = \frac{(13.15\text{ mol })}{V_2}[/tex]

Solving for V₂ yields:

[tex]\displaystyle V_2 = \frac{(100 \text{ L})(13.15)}{3.31} = 397 \text{ L}[/tex]

In conclusion, 13.15 moles of argon will occupy 397* L under the same temperature and pressure.

(Assuming 100 L has three significant figures.)

Answer:

The answer is letter D. 0./75 mol

Explanation:

Explanation: It's a 3.0 M solution so 1 litre of solution contains 3 moles of NaOH. 250 ml of solution therefore contains 0.25 x 3 = 0.75 moles of NaOH.

Answer:

Erosion.

Explanation:

It can be as small as a grain of sand or as large as a boulder. Sediment moves from one place to another through the process of erosion. Erosion is the removal and transportation of rock or soil. Erosion can move sediment through water, ice, or wind.

The probability density function is nonnegative everywhere, and its integral over the entire space is equal to the terms "probability distribution function" and "probability function" .

In probability theory, a probability density function (PDF), or density of a continuous random variable, is a function whose value at any given sample (or point) in the sample space (the set of possible values taken by the random variable) can be interpreted as providing a relative likelihood that the value of the random variable would be equal to that sample.

Probability density is the probability per unit length, in other words, while the absolute likelihood for a continuous random variable to take on any particular value is 0 (since there is an infinite set of possible values to begin with), the value of the PDF at two different samples can be used to infer, in any particular draw of the random variable, how much more likely it is that the random variable would be close to one sample compared to the other sample.

Learn more about probability density function,here:

https://brainly.com/question/30403935

#SPJ2

There are 2 electrons in the overlapping region.

Chlorine is the second member of the halogen group which are form of family of elements that resemble one another very closely.

The electronic configuration of chlorine shows the arrangement of chlorine electrons within it's atom.

At the outer most shell of the atom is seven electrons, therefore requires only one electron each to attain the octet arrangement.

The overlapping of the orbitals indicates the chemical bond formed by sharing of electrons between atoms called covalent bonding.

To complete it's outer most shell, it will need to share electron with another chlorine atom.

Therefore, there are 2 electrons in the overlapping region.

Learn more here:

https://brainly.com/question/16396974

boron, carbon, nitrogen, oxygen and flourine families in addition to the noble gases.

_________________________________________________________

also to answer the 'hello guys what is good!':nothin u?

__________________________________________

o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0

Answer:

Thermosphere

Explanation:

More specifically the ionosphere, since the ionosphere is the lower part of the thermosphere.

Hope this helps!

Answer:

cardiac muscle

Explanation:

because they help the heart to pump blood to all parts of the body

Answer:

Muscle is also very important to everyone because we need our muscles to survive. The HEART is the strongest muscle in our body and is always looking to get stronger. Muscles enable us to be active and exercise. Our strength comes for our muscles and how much they are used.

Explanation:

The emf of the cell as written is calculated to be  0.014 V.

Using the Nernst equation;

Ecell = E°cell - 0.0592/n log Q

We must note that  E°cell = 0 because the anode and cathode are composed of the same type of metal.

Now;

Substituting values, we have;

Ecell = 0 -  0.0592/3 log (0.50 M)/(0.10 M)

Ecell = 0.014 V

Learn more: https://brainly.com/question/15394851

If It takes 60mL of 0.20M of sodium hydroxide (NaOH) to neutralize 25 mL of carbonic acid ([tex]H_2CO_3[/tex]), then the concentration of the carbonic acid is 0.24M

The reaction between NaOH solution and [tex]H_2CO_3[/tex] is written below

[tex]2NaOH + H_2CO_3 \rightarrow Na_2CO_3 + 2H_2O[/tex]

Volume of NaOH, [tex]V_B[/tex] = 60 ml

Volume of [tex]H_2CO_3[/tex], [tex]V_A=25 ml[/tex]

Molarity of [tex]H_2CO_3[/tex], [tex]C_A=?[/tex]

Molarity of NaOH, [tex]C_B=0.20M[/tex]

Number of moles of [tex]H_2CO_3[/tex], [tex]n_A=1[/tex]

Number of moles of NaOH, [tex]n_B=2[/tex]

The mathematical equation for neutralization reaction is:

[tex]\frac{C_AV_A}{C_BV_B} =\frac{n_A}{n_B}[/tex]

Substitute  [tex]C_B=0.2 M[/tex],  [tex]n_A=1[/tex],  [tex]n_B=2[/tex],  [tex]V_B[/tex] = 60ml, and  [tex]V_A=25 ml[/tex] into the equation above in order to solve for [tex]C_A[/tex]

[tex]\frac{C_A \times 25}{0.2 \times 60}=\frac{1}{2} \\\\50C_A=12\\\\C_B=\frac{12}{50} \\\\C_B=0.24M[/tex]

Therefore, the concentration of the carbonic acid is 0.24M

Learn more here: https://brainly.com/question/25943090

Answer:

option D 17proton ,17electron and 18 neutrons

it wouldnt let me type it because it said it was too inappropriate

Explanation:

Answer: This would be C.) 70%

Explanation:

Answer:

b

Explanation:

Answer:

huh

Explanation:

Answer:

109.5°

Explanation:

Pls Cross Check It, If It Correct

Answer:

Combustion

Explanation:

An exothermic reaction is defined as a reaction that releases heat and has a net negative standard enthalpy change. Examples include any combustion process, rusting of iron, and freezing of water.

Combustion is a type of exothermic chemical reaction that generates light and heat in most cases, and occurs fairly quickly.

An exothermic reaction is one that when it occurs releases energy in the form of heat or light to the environment.

Therefore, we can conclude that combustion is an example of an exothermic reaction that releases large amounts of heat, which can lead to fire.

Learn more about an exothermic reaction here: https://brainly.com/question/14969584

mol = conc × v

= 1.5 × 0.09

= 0.135 moles of HCl

HCl + NaOH > NaCl + H2O

1 mole HCl = 1 mole NaOH

0.135 mol HCl = x

x = 0.135 mol NaOH

mass = mol × molar mass

= 0.135 × 40

= 5.4 g

NaOH = 23 + 16 + 1 = 40 g/mol

I'm not a 100% sure if it's correct

Answer:

C

Explanation:

2 N on left so we put a 2 on the right which makes 6 H so we need 6H on the left to do that we add a coef. of 3 to make 6 H and balance the equation

Answer:

true or false

a. very little oxygen and nitrogen are found in air. false

b. oxygen is the main cause of the formation of rust in iron.   false

c.  impure air is odourless true

.d.  plants take in oxygen gas during respiration. true

e. air contains water vapour. ​true

Explanation:

Answer:

mole

Explanation:

Since Sodium Chloride is ionic, it cannot be considered a molecule as per the definition of a molecule requires each of its components to be bonded together.

The formula mass of a compound is the mass of its one molecule. Since molecule is the basic unit of a compound. Thus, the relative formula mass in grams is the mass of one molecule.

Sodium fluoride is an ionic compound formed by the combination of sodium and fluorine by loss of one electron from sodium to fluorine. The  formula mass of fluorine is calculated from the atomic masses of sodium and fluorine.

Atomic mass of fluorine is 19 g/mol and mass of sodium is 23 g/mol. Here only one sodium and one fluorine is present. Hence the formula mass is 23+ 19 = 42.

This is the mass of one unit of NaF. Thus mass of one sodium fluoride molecule. Where as its molar mass may differ from the formula mass. Since the molar mass is the mass of one mole of the compound NaF. One mole of compound contains 6.02 × 10²³ molecules.

To refer more on formula mass, find the link:

https://brainly.com/question/28647347

#SPJ2

Answer:

730 N

Explanation:

force =mass ×acceleration

force= 73kg×10m/s

F=730N