Answer:
d = 1.65 m
Explanation:
Given that,
The speed of a ball, v = 3 m/s
A ball rolls a level table that is 1.5 m above the floor.
We can find how long the ball is in free fall. We can use the second equation of kinematics as follows :
[tex]s=ut+\dfrac{1}{2}gt^2[/tex]
u is the initial speed in the vertical direction
So,
[tex]s=\dfrac{1}{2}gt^2\\\\t=\sqrt{\dfrac{2s}{g}} \\\\t=\sqrt{\dfrac{2\times 1.5}{9.8}} \\\\t=0.55\ s[/tex]
Now, using the formula of velocity.
[tex]v=\dfrac{d}{t}\\\\d=vt\\\\d=3\times 0.55\\\\d=1.65\ m[/tex]
So, the landing spot is at 1.65 m from the table.
What are two main types of exercise???
Answer:
Endurance exercise and Strength exercise
Explanation:
Answer:
Aerob exercise and strength exercise
Explanation:
HELP PLS 100 POINTS TAKING TEST RN
Suppose you are in a car that is going around a curve. The speedometer reads a constant 30
miles per hour. Which of the following is NOT true?
You and the car are accelerating.
Your speed is constant.
Your velocity is constant.
Your acceleration is constant.
Answer:
sorry I hate when people press your question and answer with a fake answer for points, however you said it was 100 points and it's not even close lol but it is "your speed Is constant" that is not true
Plss help with my science
Answer:
rotates, axis,not sure,day, not sure, night, revolves, not sure, hemisphere, towards, summer, away, winter
Explanation:
The primary job of a(n) ____
is to increase the power of a modified radio wave.
The primary job of a(n) ____
is to increase the power of a modified radio wave.
Answer:
amplifierExplanation:
Hope it helps:)
#CarryOnLearning
Answer: Amplifier
Explanation: Edge 2021
Have a great day :D
What type of cells provide humoral immunity ?
Answer:
Antibody molecules that are secreted by plasma cells mediate the humoral immune response. The antigen that binds to the receptor of the B-cell antigen signals B cells and is internalized and transformed into peptides that activate the armed helper at the same time.
Explanation:
Answer:
B cells
Explanation:
Humoral immunity or humoural immunity is the aspect of immunity that is mediated by macromolecules found in extracellular fluids such as secreted antibodies, complement proteins, and certain antimicrobial peptides. Humoral immunity is named so because it involves substances found in the humors, or body fluids. It contrasts with cell-mediated immunity. Humoral immunity is also referred to as antibody-mediated immunity.
C) If your displacement is 19.3m and your final position is 31.8m, what was your initial position?
Answer:12.5
Explanation: Subtract
At what point in this sequence of events is potential energy
being converted to kinetic energy?
A. When the spring is recoiling B. When the spring is fully stretched. C. When the spring is fully recoiled. D. When the spring is stretching
Answer:
your answer is C
Explanation:
the spring when fully recoiled is at maximum PE and will then convert to KE
Which situations will NOT increase the reactions rate of most chemical reactions?
A) an increase in temperature
B) grind up the solute to increase surface area before mixing
C) by increasing the pressure in which the reaction takes place
D) decreasing the concentrations of the substances in the reaction
Answer:
D
Explanation:
Increasing temperature or pressure some times make the condition favorable to the reaction. Similarly increasing surface area of reacting mixture also helps to increase the reaction rate.
What is reaction rate ?The rate of a reaction is the rate of decrease in concentration of reactant or the rate of increase in concentration of the products. The rate of a reaction depends on several factors such as temperature, pressure, surface area etc.
Fir an endothermic reaction, as the temperature increases, reaction rate increases. Similarly, as the pressure increases, the reaction in which the number of moles of gaseous reactants is higher than that in products, rate increases.
The concentration of reactants must be sufficient for the reaction and decreasing the concentration of reactants does not favor an increase in reaction rate. Hence, option D is correct.
Find more on reaction rate :
https://brainly.com/question/8592296
#SPJ2
Is gravitational energy a form of kinetic energy or potential energy? Why do you think that?
Please help due today!!
Answer:
When something is lifted, work is done on the object against the pull of gravity. This work is converted to a form of potential energy called gravitational potential energy. When the item falls towards Earth like an apple from a tree, gravitational potential energy is converted into kinetic energy.
PLEASE HELP BRANILIEST
The earliest goalie masks used were made from______________________.
Group of answer choices
Stone
Candy
Fiberglass
Wood
Answer:
The earliest goalie masks used were made from Fiberglass.
Explanation:
Hope that helps
Have a good day
0.0135 kg of steam at 100°C is
cooled, which turns it into water at
50.0°C. How much heat has been
removed? (Remember, it has to
change phase before cooling
down.)
Boil Pt (°C)
Material Melt Pt (°C) 4 0/kg)
Water
0
3.33.105
L(/kg) c (J/(kg*C))
2.26.106 4186
100
(Unit = J)
Answer:
33333.35 kg
Explanation:
I got it right on Acellus, rounded to 33300 sigfigs
When 0.0135 kg of steam at 100°C is cooled, turns it into water at 50.0°C. Then 33,342.45 J of heat has been removed.
What is latent heat?Latent heat is the heat absorbed or released by a substance during a change in its physical state without a corresponding change in temperature. This means that the heat energy is being used to break or form intermolecular bonds between the particles in the substance, rather than raising or lowering the temperature. Examples of processes that involve latent heat include melting, freezing, vaporization, and condensation. The amount of heat required or released during these phase transitions is dependent on the substance and the amount of material undergoing the change.
Here in the question,
To solve this problem, we need to use the formula for the heat required to change the phase of a substance, which is given by:
Q = m * L
where Q is the heat required, m is the mass of the substance, and L is the specific latent heat of the substance.
In this case, we need to find the heat required to change 0.0135 kg of steam at 100°C to water at 100°C, and then cool it down to 50°C.
First, we need to find the heat required to change the phase of the steam to water at 100°C. Using the table given, we can see that the specific latent heat of vaporization for water is 2.26 × 10^6 J/kg. So the heat required to change 0.0135 kg of steam to water at 100°C is:
Q1 = m * L = 0.0135 kg * 2.26 × 10^6 J/kg = 30,510 J
Next, we need to find the heat required to cool the water from 100°C to 50°C. Using the specific heat capacity of water, which is 4186 J/(kg°C), we can calculate the heat required as:
Q2 = m * c * ΔT = 0.0135 kg * 4186 J/(kg°C) * (100°C - 50°C) = 2832.45 J
The total heat removed is the sum of the heat required to change the phase of the steam and the heat required to cool the water:
Q = Q1 + Q2 = 30,510 J + 2832.45 J = 33,342.45 J =33.34245 kJ.
Therefore, 33,342.45 J of heat has been removed.
To learn about specific heat click:
https://brainly.com/question/11297584
#SPJ2
A 20 kg bike accelerates at 10 m/s2. What was the force? a.200 Newtons b.20 Newtons c.25 Newtons
Answer:
a.200 Newtons
Explanation:
Given the following data;
Mass = 20kg
Acceleration = 10m/s²
To find the force;
Force is given by the multiplication of mass and acceleration.
Mathematically, Force is;
[tex] F = ma[/tex]
Where;
F represents force.
m represents the mass of an object.
a represents acceleration.
Substituting into the equation, we have
[tex] Force = 20 * 10 [/tex]
Force = 200 Newton.
Show the steps im confused.
The answer is 14 m/s
Answer:
14 m/s
Explanation:
KE=1/2mv^2
5880J= 1/2(60kg)v^2
5880J=(30)(V^2)
5880/30=V^2
196=v^2
square root of 196 is 14
Why do you think spacecraft that carry instruments to collect data about objects in space are called probes?
Answer:
my mind cant comprehend a shing word u just said
Explanation:
The probes collect data, they capture the movement in space, therefore, spacecraft that carry instruments to collect data about objects in space are called probes, So the given statement is correct.
What are Probes?
Any conductor that is placed into a plasma and gathers current is a probe. Measurements of the current on the probe as a function of the bias potential given to the probe can be used to identify a plasma's properties.
Such probes affect their surroundings while directly detecting electron and ion flows in the plasma. Any conductive material (wire, foil, chamber walls, etc.) can serve as a plasma probe; nevertheless, precise control over the probe's size, shape, and substance is necessary to achieve detectable plasma levels. Astronauts are not present aboard probes. Scientists can analyze the data the probes relay back to Earth. Sputnik 1 was the first spacecraft to launch.
Because probes probably collect data, they capture the movement in space, therefore, spacecraft that carry instruments to collect data about objects in space are called probes.
To know more about probes:
https://brainly.com/question/12992890
#SPJ2
What are some of the similar features of position vs time and velocity vs time
A layer of water Δx m thick which lies x m above the bottom of the tank will be rectangular with length 8 m. Using similar triangles, we can see that it will have widt of_____m
Answer:
x
Explanation:
The question relates to the energy required to pump water out of the
spout at the top of the triangular prism tank.
The width of the layer of water Δx thick is x m.
Reasons:
The location of the layer Δx m thick = x meters above the bottom
The length of the triangular (cross-section) prism tank = 8 meters
The length of the layer Δx thick layer = 8 meters
From the attached drawing of the cross-section of the tank, we have;
The height of the triangular tank cross-section = 3 meters
The length of the base of the triangular cross-section = 3 meters
By similar triangles, we have;
[tex]\dfrac{Height \ of \ Tank}{Base \ length \ of \ tank}= \dfrac{Height \ of \ layer \ with \ thickness \ \Delta x }{Width \ of \ layer \ with \ thickness \ \Delta x}[/tex]
Which gives;
[tex]\dfrac{3}{3} =\dfrac{x}{Required \ width}[/tex]
[tex]\dfrac{3}{3} =1 = \dfrac{x}{Required \ width}[/tex]
Required width × 1 = x
The required width = x m
Learn more here:
https://brainly.com/question/8830987
https://brainly.com/question/15695639
https://brainly.com/question/13507755