Could someone answer this for me?

Answer:

A temperature inversion occurs when air near the ground is relatively cool, and there is a layer of warmer air above it. That upper layer of warm air keeps the cooler air from rising, and traps all of the pollution in the cooler, lower layer.

Explanation:

Hope this helps

Crown me as brainliest:)

Answer:

D

Explanation:

because it was the variable that was changed in the experiment. distance was controlled and speed changed with time.

Answer:

Barium

Beryllium

Radium

Calcium

Explanation:

Answer:

The bicarbonate and carbonate ions.

Explanation:

Probably not he answer your looking for though. So, CO2.

Answer:

both Non metal's G

Explanation:

i did the test

Answer:

Explanation:

A balloon if fully inflated and then placed close to a hot place is likely to blow. This would result from the increased air pressure inside the balloon. Increase in temperature leads to an increase in the energy of the air molecules which move at a higher speed and more collisions.May 11, 2018

Answer:

9.14 x 10^22 molecules

Explanation:

Answer:

AgF (aq) + KNO₃ (aq) → AgNO₃(aq) + KF(aq)

Explanation:

AgF (aq) + KNO₃ (aq) →

The products from the equation above can be obtained as follow:

1. AgF and KNO₃ will dissociate in solution as shown below:

AgF (aq) —> Ag⁺(aq) + F¯(aq)

KNO₃ (aq) → K⁺(aq) + NO₃¯(aq)

2. A double displacement reaction will occur between AgF and KNO₃ as illustrated below:

AgF (aq) + KNO₃ (aq) →

Ag⁺(aq) + F¯(aq) + K⁺(aq) + NO₃¯(aq) → Ag⁺NO₃¯(aq) + K⁺F¯(aq)

AgF (aq) + KNO₃ (aq) → AgNO₃(aq) + KF(aq)

A careful observation of the above equation shows that the equation is balanced.

Answer:

Because the rock is irregularly shaped, you used the displacement  method to measure its volume.  You used  calculations  to indirectly find the density  of the objects.

PLZ Brainliest

Because the rock is irregularly shaped, you used the displacement method to measure its volume. You used calculations to indirectly find the density of the objects. Thus, option 1. b and 2. a is correct.

"Density has been defined as the ratio of the mass of the object to the volume of the substance." The mass of the object must be in grams and the volume is in the liter, milliliter, or cubic centimeter.

The density of the irregular-shaped rock can be calculated by the displacement method so that the volume of the rock can be estimated. The displacement method is used to calculate the volume of irregularly shaped objects. The formula is given as,

m = ρV

Here, m is mass, ρ is density and V is volume.

Therefore, the indirect calculation can be used to estimate the density.

Learn more about density, here:

https://brainly.com/question/6107689

#SPJ2

One or more new substances formed.

Answer:

d

Explanation:

100 quiz

Answer:

yea that answer he gave is correct

Explanation:

Answer:

ceasar said is a homogeneous mixture

Answer:

ceasar salad

Answer:

carbon dioxide, water, sunlight

Answer:

Hydras are generally sessile, but they can detach and move to another location by gliding slowly on their base. Sometimes they somersault, float, or use their tentacles to move along. ... If cut into several sections, a new Hydra will generate from each piece.

Explanation:

Answer:

Hydras are typically sessile, however they are able to detach and flow to every other place via way of means of gliding slowly on their base. Sometimes they somersault, float, or use their tentacles to transport along. ... If reduce into numerous sections, a brand new Hydra will generate from every piece.

Answer:

what type energy?

Explanation:

Answer:

tigers eyes

Explanation:

Answer: Gases expand to fill their containers, have a fluid nature, low density, can be compressed, diffuse and effuse - move in small hole spray perfume .

Explanation:

Gases have such an unpredictable nature like fluid, very low density, can be condensed, disperse and effuse move in tiny hole spray fragrance, and they dominate far more room than the fine solids out of which they establish. 

Because gases are harder to identify directly, gases are defined using four physical qualities or observable characteristics such as temperature, density, particles number, and volatility.

Learn more:

https://brainly.com/question/1369730?referrer=searchResults

Answer: I think the answer is 1

i just learned this about two weeks ago

Explanation:

Answer:

8.81849

Explanation:

i believe the whole number would be this but usually i round to the second decimal point, i dont know if you could do that in chemistry tho

Explanation:

The density of a substance can be found by using the formula

[tex]density = \frac{mass}{volume} \\ [/tex]

From the question we have

[tex]density = \frac{85}{110} \\ = 0.772727272...[/tex]

We have the final answer as

The substance will float on water since it's density is less than that of water which is

1 g/cm³.

Hope this helps you

volume of ozone : 19.15 ml

Graham's law: the rate of effusion of a gas is inversely proportional to the square root of its molar masses or

[tex]\tt \dfrac{r_{CO_2}}{r_{O_3}}=\dfrac{\sqrt{M_{O_3}} }{\sqrt{M_{CO_2}}} }[/tex]

rate of CO₂  , M CO₂ = 44,01 g/mol

[tex]\tt r~CO_2=\dfrac{20~ml}{100~s}[/tex]

[tex]\tt r~O_3=\dfrac{x}{100~s}[/tex]

volume of ozone

[tex]\tt \dfrac{r~{CO_2}}{r~O_3}=\dfrac{\sqrt{48} }{\sqrt{44.01} }\\\\\dfrac{20}{x}=\dfrac{\sqrt{48} }{\sqrt{44.01} }\\\\x=\dfrac{20.\sqrt{44.01} }{\sqrt{48} }=19.15~ml[/tex]

Answer: 20

Explanation: I’m in your class.

Answer:

The absolute uncertainty is approximately 1.69 × 10⁻³

Explanation:

The volume needed for NaOH needed to make the solution = 16.66 ml

The wt% of the added NaOH = 53.4 wt%

The volume of the NaOH to be prepared = 2.00 L

The concentration of the NaOH to be prepared = 0.169 M

The molar mass of NaOH = 39.997 g/mol

Therefore, 100 g of sample contains 53.4 g of NaOH

The mass of the sample = 16.66 × 1.52 = 25.3232 g

The mass of NaOH in the sample = 0.534 × 25.3232 = 13.5225888 g ≈ 13.52 g

Therefore;

The number of moles of NaOH = 13.52/39.9971 = 0.3381 moles

Therefore, we have 0.3381 moles in 2.00L solution, which gives;

The number of moles per liter = 0.3881/2 = 0.169045 moles/liter

The molarity ≈ 0.169 M

The absolute uncertainty, u(c) is given as follows;

[tex]u(c) = \sqrt{ \left (\dfrac{0.01}{16.66} \right )^2 + \left ( \dfrac{0.4}{53.4} \right )^2 + \left ( \dfrac{0.01}{1.52} \right )^2 } \times 0.169 \approx 1.69 \times 10^{-3}[/tex]

The absolute uncertainty, u(c) ≈ 1.69 × 10⁻³.

Answer:

The correct option is D) Humidity levels will rise

Explanation:

A rise in humidity means that it is most likely there is going to be a rain.

When blue semi-circle lines with triangles approach red semi-circle lines it is a situation where cold front is approaching a warm front.

The resultant effect is that the warm and cold air both come to a standstill. This will most likely trigger cloud and fog and may even lead to rain.

Cheers

Answer:

To convert among units in the metric system, identify the unit that you have, the unit that you want to convert to, and then count the number of units between them. If you are going from a larger unit to a smaller unit, you multiply by 10 successively. If you are going from a smaller unit to a larger unit, you divide by 10 successively

Explanation:

hope it helps