ery active on
riodic table
2
c table
Which one is more reactive out of Fluorine and Chlorine? Why?
A small portion of Modern periodic table (Group 1) is given. Givet
hydrogen along with metals in this
group.
3. Elements of
group 1, 2, 13 are more reactive as we go down in the
table, why?
Modern periodic table is less defective than Mendeleev's periodic
to justify it.
Group-C
eley's per
Mention any three characteristics of Mendeleev's periodic table.
Write down the three drawbacks of Mendeleev's periodic table.
Write down three characteristics of Modern periodic table.
Which group of the periodic table does the element ‘A’ belong to
reactive in between 'B' and 'C'? Give reason.
Element
Electronic configuration
А
2,8,5
B
2,3
C С
2,8,3
Identify the groups of the alkali metals, metalloids and inert g
8
What is the valency of chlorine and neon? Why?
2
13
14
15
16
17​

Answer:

Actinides

Explanation:

The actinides are valuable primarily because they are radioactive.

Answer:

3.18 L

Explanation:

Step 1: Given data

Step 2: Convert P₁ to mmHg

We will use the conversion factor 1 atm = 760 mmHg.

0.985 atm × 760 mmHg/1 atm = 749 mmHg

Step 3: Calculate the final volume of the gas

Assuming ideal behavior and constant temperature, we can calculate the final volume using Boyle's law.

P₁ × V₁ = P₂ × V₂

V₂ = P₁ × V₁/P₂

V₂ = 749 mmHg × 3.65 L/861.0 mmHg = 3.18 L

Answer:

B

Explanation:

They lose energy and slow down and move closer to other gas molecules and the molecules collect together to form a liquid

Answer:

B.  They lose energy.

Explanation:

took the test, can confirm it's b ヾ(•ω•`)o

Answer:

B

Explanation:

Answer:

Title.

Abstract.

Introduction.

Method.

Results and analysis.

Discussion.

Conclusion.

References.

The term for the heaviness on something's surface that exerts a force over an area is pressure. The correct option is b. pressure

From the question, we are to determine the term for the heaviness on something's surface that exerts a force over an area.

Here, we are talking about pressure.

Pressure is defined as the physical force exerted on an object. Mathematically, it is defined as the perpendicular force per unit area.

That is,

[tex]P = \frac{Force}{Area}[/tex]

Where P is the pressure

The units of pressure are Newtons per square meter (N/m²), Pascals etc.

Hence, the term for the heaviness on something's surface that exerts a force over an area is pressure. The correct option is b. pressure

Learn more on Pressure here: https://brainly.com/question/16789304

Answer:

A. 324 J

Explanation:

Option D I got it right

ANSWER: C (ENERGY WAS RELEASED WHEN THE MOLECULE WAS FORMED FROM ITS ELEMENTS.)

HOPE THE OTHER PERSON IS WRONG!

Answer:

the reaction is: Na2CO3 + 2HCl ===》 2NaCl + H2O + CO2(g)

Answer:

The angle of incoming sunlight varies at different places

Answer: This answer is multiple choices.

1. Land and water have different heat capacities.

And

3. The angle of incoming sunlight varies at different places.

Explanation: I kept seeing other people only putting in one answer, so I used this answer from someone else. Credit to them!

Answer:

please follow me

Explanation:

A displacement reaction is the one when a more reactive substance displaces a less reactive one from its salt solution whereas a double displacement reaction is the one where a mutual exchange of ions happens between two compounds.

Respiration is the chemical process by which organic compounds release energy. The compounds change into different ones by exergonic reactions. The hydrolysis of adenosine triphosphate (ATP) to adenosine diphosphate (ADP) and phosphoric acid (Pi) releases energy (it is an exergonic reaction).

Answer:

the force applied to the rubber band is -9.3N

Explanation:

The computation of the force applied to the rubber band is shown below;

We know that

Force in newtons = Spring constant × amount of extension

F = -k × x

where

-k = 62 N/m

And, x = 0.15m

So, the force applied is

= -62N/m × 0.15m

= -9.3N

hence, the force applied to the rubber band is -9.3N

the force applied to the rubber band is -9.3N

Explanation:

Answer:

salt

Explanation:

When acid and base solutions react, they produce water and a neutral ionic compound called a salt.

Answer:

Volume of 6.5 moles of Helium at STP is 145.6954 L

Explanation:

As we know

[tex]pV = nRT[/tex]

At STP, temperature is  273.15 K  and pressure is  1 atm

n is the number of moles which is equal to 6.5

R is the gas constant = 0.08206 L atm/K mol

Substituting the given values in above equation, we get -

[tex]1 * V = 6.5 * 0.08206 * 273.15\\V = 145.6954[/tex]Liters

Volume of 6.5 moles of Helium at STP is 145.6954 L

The solute wether electrolyte or a nonelectrolyte, has the greater effect on the boiling point when a given amount of each solute is dissolved in the same mass of water The nonelectrolyte does because it dissociates into ions.

Solute refers to substances or liquid which can readily dissolve in a solvent. It's concentration is lower to that of solvent.

Therefore, The solute wether electrolyte or a nonelectrolyte, has the greater effect on the boiling point when a given amount of each solute is dissolved in the same mass of water The nonelectrolyte does because it dissociates into ions

Learn more about solute below.

https://brainly.com/question/16083884

#SPJ2

Answer:

D: The electrolyte does because it dissociates into ions.

Explanation:

sliding

This is the answer

Answer:

Yes, it does, it helps very much :))

Explanation:

Answer:

K = 0.5

Explanation:

Based on the reaction:

PCl₃ + Cl₂ ⇄ PCl₅

The equilibrium constant, K, is defined as:

K = P PCl₅ / P PCl₃ * P Cl₂

Where P represent the pressure at the equilibrium for each one of the gases involved in the equilibrium.

As:

P PCl₅ = 1.0atm

P PCl₃ = 1.0atm

P Cl₂ = 2.0atm

K = 1.0atm / 1.0atm * 2.0atm

Answer:12

Explanation:

Answer:

I think it's thermochemical reaction and sorry if it's wrong

Answer:

The initial volume in mL is 5959.2 mL

Explanation:

As the number of moles of a gas increases, the volume also increases.  Hence, number of moles and volumes are directly proportional i.e

n ∝ V

Where n is the number of moles and V is the volume

Then, n = cV

c is the proportionality constant

∴n/V = c

Hence n₁/V₁ = n₂/V₂

Where n₁ is the initial number of moles

V₁ is the initial volume

n₂ is the final number of moles

and V₂ is the final volume.

From the question,

n₁ = 0.693 moles

V₁ = ?

n₂ = 0.928 moles

V₂ = 7.98 L

Putting the values into the equation

n₁/V₁ = n₂/V₂

0.693 / V₁ = 0.928 / 7.98

Cross multiply

∴ 0.928V₁ = 0.693 × 7.98  

0.928V₁ = 5.53014

V₁ = 5.53014/0.928

V₁ = 5.9592 L

To convert to mL, multiply by 1000

∴ V₁ = 5.9592 × 1000 mL

V₁ = 5959.2 mL

Hence, the initial volume in mL is 5959.2 mL

Answer:

Ar(Mg)=24g

Ar(Cl)=35,5 and Cl2=35,5×2=71g

m=24g+71g=95g

Answer:

1 respuesta. fórmula empírica = CH2

Explanation:

Translatation: 1 Answer. empirical formula = CH2

Answer:

220.9g of water are required

Explanation:

The molar enthalpy of vaporization is defined as the heat released when 1 mole of water changes from liquid to gas.

For water, 1 mole releases 40.79kJ. To release 500kJ are necessaries:

500kJ * (1mol / 40.79kJ) = 12.26 moles are necessaries

To convert moles to grams we must use the molar mass (H2O = 18.02g/mol):

12.26 moles * (18.02g / 1 mol) =

Answer: The volume of hydrogen produced is 0.122 L

Explanation:

To calculate the moles :

[tex]\text{Moles of solute}=\frac{\text{given mass}}{\text{Molar Mass}}[/tex]

[tex]\text{Moles of solute}={\text{Molarity}}\times {\text{Volume in L}}[/tex]  

[tex]\text{Moles of} Mg=\frac{5.00g}{24g/mol}=0.208moles[/tex]

[tex]\text{Moles of} HCl=[/tex][tex]0.100moldm^{-3}\times 0.1dm^3=0.01mol[/tex]

The balanced chemical equation is:

[tex]Mg+2HCl\rightarrow MgCl_2+H_2[/tex]  

According to stoichiometry :

2 moles of require = 1 mole of

Thus 0.01 moles of [tex]HCl[/tex] will require=[tex]\frac{1}{2}\times 0.01=0.005moles[/tex]  of [tex]Mg[/tex]

Thus is the limiting reagent as it limits the formation of product and is the excess reagent.

As 2 moles of give = 1 mole of

Thus 0.01 moles of [tex]HCl[/tex] give =[tex]\frac{1}{2}\times 0.01=0.005moles[/tex]  of [tex]H_2[/tex]

According to ideal gas equation:

[tex]PV=nRT[/tex]

P = pressure of gas = 1.0 atm  (SATP)

V = Volume of gas = ?  

n = number of moles = 0.005

R = gas constant =[tex]0.0821Latm/Kmol[/tex]

T =temperature =[tex]25^0C=(25+273)K=298K[/tex] (SATP)

[tex]V=\frac{nRT}{P}[/tex]

[tex]V=\frac{0.005mol\times 0.0820 L atm/K mol\times 298K}{1.0atm}=0.122L[/tex]

Thus volume of hydrogen produced is 0.122 L

Answer:

D - Hydroxide Ion (OH-)

Explanation:

A base provides either hydroxide ions (OH–) or other negatively charged ions that combine with hydrogen ions, reducing their concentration in the solution and thereby raising the pH. In cases where the base releases hydroxide ions, these ions bind to free hydrogen ions, generating new water molecules.