Answer:
Option B is correct
Explanation:
Here the
Mass number of carbon is 11 and that of boron is 11. While the atomic number varies by a a unit 1 value.
Thus, on the right hand side, a particle with atomic number 1 and mass number 0 is released
Thus, option B is correct
If a chemical reaction has a AH value of -125 kJ, it would be considered what?
A. an exothermic reaction
B. a reaction that absorbs energy
C. an endothermic reaction
D. A reaction that probably gets cold
exothermic
Explanation:
negative means it's losing energy
A glass falls from a table top and smashes on the floor 0.6 seconds later. How high is the table?
Equations that can be used
Vv=gt, dv=1/2gt^2, t=2d/g.
Answer:
1.8 m
Explanation:
Given: Glass falls from a table, smashes 0.6 seconds later
To find: How high a table is
Formula: Vv=gt, dv=1/2gt^2, t=2d/g
Solution: A table's height is measured from the top of the edge down to the floor. The tables are shown both have a height of 30 inches, which is common for many tables.
Data
t = 0.6sg = 9.81 m/s²d = ?Equation
d = [tex]\frac{1}{2}[/tex][tex]gt[/tex]²Math & Units
d = 4.905 (0.6²)d = 442.676Hence the table is 1.8 m high
Light waves Group of answer choices are not electromagnetic radiation. do not require a medium. can not travel in a vacuum. do not travel in straight lines from the source.
Answer:
do not require a medium
Explanation:
Light waves can be regarded as electromagnetic waves and it transverse in nature, no medium material is required to pass through. Light wave can travel through vacuum and it's ray can travel in straight lines even from point source. Light convey energy in perpendicular direction to electric field as well as magnetic field.
A runner of 60kg accelerates at 2.0 m/s at the start of race calculate the force provided from her legs
Answer:
120 kgm/s
Explanation:
Force= mass× acceleration
= 60kg × 2.0m/s
= 120 kgm/s
The ratio of the speed of light in a medium to the speed of light in a vacuum
is called its:
A. angle of incidence
B. Snell's Law
C. angle of refraction
D. refractive index
Answer:D.Refractive Indez
Explanation:
It is usually expressed the other way: the ratio of the speed of light in a vacuum to the speed of light in a medium. In that case, it is called the "index of refraction".
You're going for "refractive index", but you've got the ratio flipped over.
PLZZZZ HELPPPPPP MEEEEEE!!!!!! ILL GIVE 20 POINTS AND BRAINLIEST!!!
:'(
I am desperate guys.
Answer:
c.
Explanation:
In positron emission, also called positive beta decay (β+-decay), a proton in the parent nucleus decays into a neutron that remains in the daughter nucleus, and the nucleus emits a neutrino and a positron, which is a positive particle like an ordinary electron in mass but of opposite charge.
Does this help? Sorry it's wordy that's just how my teachers taught me :'(
An object is travelling 15 m/s. How long does it take for it to go 75 m?
Answer:
5 seconds
Explanation:
When you use a microwave, what is the main way that heat is transferred?
1. radiation
2. convection
3.conduction
Answer:
the correct answer is 1. radiation
what type of beetle is this?
Please answer correctly
No trolling or links, please
Answer: Wave a the first answer is right
Brainliest.
Explanation:
Un atleta tiene en un instante dado una velocidad de 4 m/s. Si a partir de ese instante y durante 2 s adquiere un MRUA con una aceleración de 3 m/s2. Calcula la velocidad que alcanza al cabo de esos 2 s.
Answer:
Velocidad final, V = 8 m/s
Explanation:
Dados los siguientes datos;
Velocidad inicial, u = 4 m/s
Aceleración, a = 2 m/s²
Tiempo, t = 2 segundos
Para encontrar la velocidad final (v), usaríamos la primera ecuación de movimiento;
V = u + at
Sustituyendo en la fórmula, tenemos;
V = 4 + 2*2
V = 4 + 4
Velocidad final, V = 8 m/s
El diámetro del embolo de una jeringa para inyección mide 1.5 cm. Una enfermera ejerce una fuerza de 2N cuando inyecta a su paciente. Calcule la presión que ejerce el fluido inyectado sobre las venas.
Answer:
Presión = 11111,11 N/m
Explanation:
Dados los siguientes datos;
Diámetro = 1,5 cm a metros = 1,5 / 100 = 0,015 m
Fuerza = 2N
Para encontrar la presión;
En primer lugar, determinaríamos el área del círculo usando la fórmula;
Área del círculo = πr²
Radio = diámetro/2 = 0.015/2 = 0.0075 m
Área de la jeringa = 3.142 * 0.0075²
Área de la jeringa = 3.142 * 0.00005625
Área de la jeringa = 0.00018 metros
Ahora, podemos encontrar la presión usando la fórmula;
Presión = fuerza/área
Presión = 2/0.00018
Presión = 11111,11 N/m
what does heat trapped by pollution cause?
A. Acid rain
B. Decomposition
C. Greenhouse effect
Answer:
C. Greenhouse Effect
Explanation:
The greenhouse effect is caused by heat trapping pollution in the atmosphere.
A 60 Watt bulb runs for 60 s. How much work does it do?
Two train cars with the same mass (30,000 kg) are traveling in the same direction when they collide.
Train Car A has a velocity of 10 m/s and Train Car B has a velocity of 5 m/s. What is their total
momentum after the collision? Make sure to show all your work and include proper units.
Answer:
25
Explanation:
I just did this
After the collision, car 1 has a final velocity of 6m/s south. What is the final velocity of car2?
a) 35m/s north
b) 35m/s south
c) 81 m/s north
d) 81 m/s south
Write 3 rules that describe the possible behaviors that occur when objects with different charges are brought close together
Explanation:
1. attract
2.repel
3. no effect
Simplify 45÷3+2×8-12+42
Answer:
Explanation is in the picture and the answer is 16
Why does steam at 100°c give severe burn than water at 100 c?
Explanation:
Steam will produce more severe burns than boiling of water because steam has more heat energy than water due to its latent heat of vaporisation and additionally latent heat of condensation. Steam and boiling water can exist at varing temperature but it is only correct to assume here that both are at same temperature.
A high diver dives off a platform and strikes the water 1.857 seconds later. Ignoring air resistance, how fast is he traveling as he strikes the water in m/s?
Answer:
The (vertical) speed of the driver as he strikes the water is approximately 18.22 m/s
Explanation:
From the parameters given in the question, we have;
The time after which the driver strikes the water after he drives off a platform, t = 1.857 s
Let 'v' represent the vertical speed of the driver
We can find the vertical speed of the vehicle as it strikes the water as follows;
v = u + g·t
Where;
v = The final vertical velocity of the driver
u = The initial vertical speed of the driver = 0 m/s
g = The acceleration due to gravity ≈ 9.81 m/s²
t = The time of motion = 1.857 seconds
Therefore, we have;
v = 0 + 9.81 m/s² × 1.857 s = 18.21717 m/s
Therefore;
The vertical speed of the driver as he strikes the water, v ≈ 18.22 m/s
How do positive and negative acceleration differ?
Positive acceleration represents an object speeding up; negative acceleration represents an object slowing down.
Positive acceleration moves north or east; negative acceleration moves south or west.
Positive acceleration occurs when there is more velocity than speed; negative acceleration occurs when there is less velocity than speed.
Positive acceleration occurs when an object changes its speed but not its direction; negative acceleration occurs when an object changes both its speed and direction.
Answer:
Positive acceleration moves north and east but negative acceleration moves south and west
If you walk for 1.5 hours at an average speed of 4 miles/hr. How far will you have walked?
What is the minimum force required to increase the energy of a car by 69 J over a distance of 42 m? Assume the force is constant.
Group of answer choices
0.61 N
69 N
2900 N
1.6 N
110 N
That minimum coefficient of static friction between the tyres and the road that will allow the car that will round safely.
Answer:
The answer is "[tex]0.13562748[/tex]"
Explanation:
Please find the complete question in the attached file.
Using formula:
[tex]\bold{U_s=\frac{v^2}{rg}}[/tex]
Given:
[tex]r=1.60 \times 10^2 \ m\\\\g=9.8\\\\v= 52.5\ \frac{km}{hr}= 14.583\ \frac{m}{s}[/tex]
put the value into the above-given formula:
[tex]U_s= \frac{14.583^2}{160 \times 9.8}[/tex]
[tex]= \frac{212.663889}{1568}\\\\=0.13562748[/tex]
If an electron moves in a circle of radius 21 cm perpendicular to a B field of 0.4 T, what are the speed of the electron and the frequency of motion?
Answer:
a)
[tex]v = 4.048 *10^6[/tex] m/s
b)
Angular frequency = [tex]1.92 * 10^7[/tex]
Explanation:
As we know
[tex]v = \frac{qBr}{m}[/tex]
q is the charge on the electron = [tex]3.2 * 10^{-19}[/tex] C
B is the magnetic field in Tesla = [tex]0.4[/tex] T
r is the radius of the circle = [tex]0.21[/tex] m
mass of the electrons = [tex]6.64 * 10^{-27}[/tex] Kg
a)
Substituting the given values in above equation, we get -
[tex]v = \frac{3.2 * 10^{-19}*0.4*0.21}{6.64 * 10^{-27}} \\v = 4.048 *10^6[/tex]m/s
b)
Angular frequency =
[tex]\frac{4.048 * 10^6 }{0.21} \\1.92 * 10^7[/tex]
How does magnetic compass help to identify directions
Answer:
By the help of magnetic field of the earth
Explanation:
Compasses, also known as magnetic compass, help us primarily in navigating and determine position on the globe. The planet Earth has its own magnetosphere or magnetic field that is close with that of a magnetic poles, and this is how compass works. The compass needle aims north and south as it happens to coincide with the Magnetosphere or magnetic field.
write your opinion about achievement made by during rana rule
Answer:
Your opinion about achievement made by during rana rule
Explanation:
April Fools !
hence, the force needed to accelerate the 1000kg car by 3m/s2 is 3000N
Answer:
i'll answer your question but follow me first
1. Oh no! Your car breaks down on the highway, and you have to push the car to the side of the road. If your car is 400 kg and you push
with a force of 200 N, what is the car's acceleration?
O 2 m/s2
O 8.0 x 104 m/s2
O 0.5 m/s2
Oom/?
How does the strength of a magnetic field around a wire vary?
Answer:
By pointing one's right thumb along the direction of the current, the direction of the magnetic field can by found by curving one's fingers around the wire. The strength of the magnetic field depends on the current I in the wire and r, the distance from the wire.